Determine the x-y and z components of reaction at the pin

Assignment Help Civil Engineering
Reference no: EM13308521

The member is supported by a pin at A aand a cable BC. If the load at AD is 300 lb, determine the x,y,z components of reaction at the pin A and the tension in cable b c

Reference no: EM13308521

Questions Cloud

Determine the coliform concentration at the beach : An ocean outfall diffuser that discharges treated wastewater into the Pacific Ocean is 500m from a public beach. The wastewater contains 105 coliform bacteria per milliliter. The wastewater discharge flow rate is 0.3 m3/s.
Marketing plan format : Marketing plan format is one that is utilized by major corporations all over the country. However, writing a comprehensive marketing plan is a difficult and challenging task, yet, the ability to write such a plan is critical to the development of a m..
Determine the true horizontal legth of the distance measured : A 100-ft steel tape was used in the field to measure a distance of 247.53 ft. the following data represents the conditions in the field at the time of measurement: tempreture = 41 F, tension = 30 ib, and tape supported at ends only.
Find the direction at the location of the charge : A -19 mC charge experiences a force of 60 N directed south. What is the electric field magnitude and direction at the location of the charge
Determine the x-y and z components of reaction at the pin : The member is supported by a pin at A aand a cable BC. If the load at AD is 300 lb, determine the x,y,z components of reaction at the pin A and the tension in cable b c
Acquisitions allow firms to capture new capabilities : Acquisitions allow firms to capture new capabilities.
Acquisitions allow firms to capture new capabilities : Acquisitions allow firms to capture new capabilities.
What is lump-sum equivalent cost of project at present time : A major relining of the combustion vessel will occur during the fifth year at a cost of $30,000. If the interest rate is 15% per year, what is the lump-sum equivalent cost of this project at the present time
Discuss economic endowments of japan : Discuss economic endowments of japan.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine how far apart must two diameter tanks be placed

How far apart must two 18 , diameter tanks be placed such that their stress overlap is not greaer than 10% of the contact stress at depths of 10, 20, and 30 m

  Determine the sludge age and cell wastage flow rate

Assume: Suspended solids in effluent negligible Wastage is from aeration tank Yield coefficient = 0.4 Bacterial decay rate = 0.04 1/d Effluent BOD5 = 10mg/L F/M = 0.33 mg/mg*d BOD5 after primary settling = 150mg/L MLVSS = 1700mg/L MLSS = 1.4(MLVSS..

  Find the station and elevation of the low point of the curve

On a certain highway a -6% grade meets a +2% grade at station 70 + 00, elevation 550.97 ft. An equal tangent vertical curve, 800 ft. long, is to be installed to connect these two grades.

  Determine the maximum shear stress in the shaft

A solid steel shaft with an outside diameter of 65 mm is subjected to a pure torque of 7,000 N-m. The shear modulus of the steel is G=80 GPa. Determine a. 1 The maximum shear stress in the shaft

  Compute atomic packing factor for diamond cubic crystal

Assume that bonding atoms touch one another, that the angle between adjacent bonds is 109.5, and that each atom internal to the unit cell is positioned a/4 of the distance away from the two nearest cell faces.

  Determine what will be the hydraulic conductivity of the gcl

If this GCL is used as a liner beneath a 55-ft high landfill with a waste unit weight of 45 lb/ft3, what will be the hydraulic conductivity of the GCL at the bottom of the landfill

  Determine normal depth and froude number a pvc pipe

A PVC pipe with a diameter of 30 inches will carry a flow of 20 cfs. the bottom slope is 0.005 and the roughness coefficient is 0.015. determine the normal depth, critical depth, velocity and the froude number.

  At what rate is the diameter increasing after 5 min

A balloon is being inflated at the rate of 15m^3/min. At what rate is the diameter increasing after 5 min? Assume that the diameter is zero at time zero.

  Compute the final temperature and pressure of the gas

A tank is divided into two equal chambers by an internal diaphragm. One chamber containes methane at a pressure of 500 bar and a temperature of 20 C, and the other chamber is evacuated.

  Determine length of an interval of time for atleast one call

determine the length of an interval of time such that the probability of at least one call in the interval is 0.90

  Determine the couple m required to hold the system

the pin at B is attached to member ABC and can slide freely along the slot cut in the fixed plate. Neglecting the effect of friction, determine the couple M required to hold the system in equilibrium when.

  What was students associated perception per reaction time

An engineering student is driving on a level roadway and sees a construction sign 500 ft ahead in the middle of the roadway. the student strikes the sign at a speed of 25 mi/h.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd