Determine the work done and the heat transfer

Assignment Help Civil Engineering
Reference no: EM13563801

1.A standard reverse-flow cyclone with a length of 5cm has a cut diameter of 250 microns. at a flow rate of 10^-7 m^3/s, what would the diameter corresponding to 90%removal be?

2.Water, initially dry saturated vapour at 4 bar, lls a closed rigid con- tainer. The water is heated until its temperature is 400C. Determine the work done and the heat transfer.

3.What is the elongation of a rectangular bar (cross section 2 inch * 2 inch length 4 ft) When it is subjected to an axial load of 80,000 lbs. Assume the material of the bar has the following properties G = 7,700 KSI, V =0.30

Reference no: EM13563801

Questions Cloud

Determine the exit temperature : A mixture by volume of 50% hydrogen and 50% carbon dioxide is flowing isentropically through a nozzle with flow rate of 1 m^3/s measured at inlet condition of 700 kpa and 373k the inlet velocity is negligible and the mixture expands to a pressure of ..
Determine the minimum temperature in the cycle : A reversed brayton cycle operates with air entering the compressor at 1 bar and 7 c and leaving at 4 bars air enters the turbine at 37 c the compressor and the turbine efficients are 84% and 88% respectivelt determine
Estimate the value of the fuel that is captured if the vapor : Gasoline vapors are vented to the atmosphere when an underground gasoline storage tank is filled. If the tanker truck discharges into the top of the tank with no vapor control
Compute and tabulate the azimuths from the following 3-sided : Compute and tabulate the azimuths from the following 3-sided traverse where course ab is due north. angles are to the right. include a sketch.
Determine the work done and the heat transfer : Water, initially dry saturated vapour at 4 bar, lls a closed rigid con- tainer. The water is heated until its temperature is 400C. Determine the work done and the heat transfer.
What is the concentration of nox : It has been estimated that the emission of NOx from a coal fired power plant is 1300 g/s. At 100 km downwind (y=10m), what is the concentration of NOx in g/m^3. The wind speed at the top of the stack with a height of 100m is 6.5 m/s and an inversion ..
What is the maximum flowrate in the business can discharge : A business wishes to discharge salt into a river. the concentration of salt from the business is 210 mg/L. the flow of water in the river (upstream) is 0.5 m^3/s. Upstram the concentration of salt in the river 15 mg/L.
What is the theoretical rate of moisture removal : Moisture in the hot drying air condensing on the cooler grain near the plenum of the bin (Hint: The vapor in the ambient will condense out if the temperature of a surface is lower than the incoming air dew-point temperature).
Determine the station of the point where the superelevation : A 6 lane highway has 12 ft lanes and a crown cross-slope of 0.02 ft/ft. The design speed of the road is 60 mph. The station of the PC is 20+00. Determine the station of the point where th superelevation runoff begins

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the discharge from the pipe

Flow occur throught a sand-filled pipe with a cross-sectional area of 60 cm^2. If K is 10^-3 cm/s and the gradient is 0.01, what is the discharge from the pipe

  Determine the maximum tension t that can be exerted

If a hook can sustain a maximum withdrawal force of 250 N inthe vertical direction, determine the maximum tension, T, that can be exerted.

  Determine the volume flow rate of water

Water with a static pressure of 1.96kN/M 2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M 2 . How do you determine the volume flow rate (Q) of the water? (Q = 1.40 M^3/sec, V=2.79 M/se..

  Type of reaction involving protonated alcohol

The reaction between 2-methyl-2-pentanol and HBr to yield 2-methyl-2-pentene is probably: A) an E1-type reaction involving the protonated alcohol as the substrate. B) an SN2-type reaction involving the protonated alcohol as the substrate.

  Determine the amount of coal used per day if the heat of

A coal fired power plant can be modeled as a heat engine. If the power output of the plant is 200 MW and the thermal efficiency is 42%, determine the amount of coal used per day if the heat of combustion from the coal is 24,000 kJ/kg.

  How to determine the efficiency of the pump

Water is pumped at a rate of 1.57 cfs from one large open tank into another through a 6 in diameter cast iron pipe 400 ft long. The water level in the second tank is 160 ft above the level of the first tank and the discharge end of the pipe is sub..

  Determine whether the crystal structure for this alloy is

Some hypothetical alloy is composed of 12.5 wt% of metal A and 87.5 wt% of metal B. If the densities of metals A and B are 4.27 and 6.35 g/cm3, respectively, whereas their respective atomic weights are

  What is the present worth of the road at an interest rate

The cost of extending a certain road is $850,000. Resurfacing and other maintenance are expected to cost $175,000 every 3 years and lasts for 96 years. What is the present worth of the road at an interest rate of 6% per year (over that period)

  Determine the new q through the system at c

Parallel pipes, fixed overall H, ?EGL or hl = 75'. Elevated Tank A water surface is at El 625, 3000' away is Tank B with free surface El 550 They are connected by a 12" dia cast iron pipe.

  Calculate factor of safety if the material does not yield

The program should use both the maximum shearing-strength criterion and the maximum-distortion-energy criterion. It should also print the values of the principal stresses and, if the material does not yield, calculate the factor of safety.

  How to derive the unit hydrogaph by the inverse procedure

Given below are the measured stream flows in cfs from a storm of 6-hour duration on a stream having a drainage area of 185 mi^2. Derive the unit hydrogaph by the inverse procedure. Assume a constant base flow of 550cfs.

  Coefficient of static friction between pacakges

The belt starts from rest at time t=0 and its speed increases at a constant rate of 150mm/s^2. Knowing that the coefficient of static friction between the pacakges..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd