Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Two metallic terminal protrude from a device. The terminal on the left is the positive reference for a voltage called vx(the other terminal is the negative reference). The terminal on the right is the positive reference for a voltage called v y (the other terminal being the negative reference). If it takes 1 mJ of energy to push a single electron into the left terminal, determine the voltages vx and vy.
The input signal (inflow minus outflow) to an integral process varies sinusoidally at a radian frequency, omega i. of 0.025 rad/s. The output signal varies sinusoidally at the same frequency with an amplitude of 10%.
A vibration trandsucer measures a sinusoidal signal with up to a 100-hz frequency and an amplitude of + and - 5 v. Superimposed on this signal is an additional signal with a freq of 1000 hz. and amplitude of .2
The parking lot of the Spenditall Megamall has an area of 128 ac. It is partially landscaped to provide some areas of grass. Assume that an average of 63% of the water that falls on the parking lot will flow
The return current is through the outer conductor, which consists of an infinitely thin cylindrical shell of radius b. Use Ampere's law to calculate the magnetic field intensity everwhere.
Describe the how the Hall Effect it is used to measure whether a semiconductor material is n-type or p-type. Sketch a diagram and show the critical measurements.
A piston-cylinder device contains carbon dioxide CO2 (molar mass = 46 g/mol) as shown in the figure. The cross-section area of the piston is 0.25 m2 and the initial cylinder height is 50 cm. CO2 is initially at 40 bar and 500 oC (state 1).
What is the peak frequency deviation of the FM signal? What is the FM improvement in dB?
How would you develop a looping program in MIPS that will take a series of decimal numbers and arrange them in ascending order from smallest to largest. The sequence of nine numbers are: 5, 3, 8, 9, 2, 4, 1, 7, 6, 3, 8
Suppose that the source charges of the two previous problems are present together. The potential at infinity is defined to be 0. a. Is the potential at the point (0.5, 0.5, 0.5) positive, negative, or zero b. Is the potential at (4, 4, 4) positive
Consider the following signal y[n]; y[n] = X1[n+3] * X2[n] The signals X1 and X2 are defined as X1[n]=((1/2)^n) u[n] X2[n]= ((1/3)^n u[n] Determine the Z transform of y[n].
A 30-km, 34.5-kV, 60-Hz three-phase line has a positive-sequence series impedance z = 0.19 + j0.34 ?/km. The load at the receiving end absorbs 10 MVA at 33 kV. Assuming a short line, calculate: (a) ABCD parameters,
A MOSFET is used in a boost-buck converter. The on-state loss is 4.2 W, and the switching loss is 2.8 W. The device is in TO-220 heat-sink package. it is desired to avoid a heat sink, and a parallel connection has been suggested.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd