Determine the value of r2 for maximum power to r4

Assignment Help Electrical Engineering
Reference no: EM131204203

a. For the network of given figure (a), determine the value of R2 for maximum power to R4.

b. Is there a general statement that can be made about situations such as those presented here and in given Problem?

1177_Network a.jpg

Problem

Find the resistance R1 of figure (b) such that the resistor R4 will receive maximum power.

1572_Network b.jpg

Reference no: EM131204203

Questions Cloud

Find the resistance r1 of given figure : Find the resistance R1 of given figure such that the resistor R4 will receive maximum power.
How does a change in tax rate affect this level of income : How does a change in the tax rate affect this level of income?
What was the reported net income or loss for the year : On January 1, Christopher's reported total stockholders' equity of $1,300. During the year, $50 of dividends were declared and paid, donated land with a donor book value of $14 and a current fair value of $38 was received, additional common stock was..
Historical question or a moral question : You will now write an introduction stating your position by answering whether you think the impact European contact had on the indigenous populations of North America should be addressed as a historical question or a moral question.
Determine the value of r2 for maximum power to r4 : For the network of given figure (a), determine the value of R2 for maximum power to R4.- Is there a general statement that can be made about situations such as those presented here and in given Problem?
How much cash is available for distribution to the partners : Everett, Miguel, and Ramona are partners, sharing income 1:2:3. After selling all of the assets for cash, dividing losses on realization, and paying liabilities, the balances in the capital accounts are as follows: Everett, $50,000 Cr.; Miguel, $40,0..
What is the definition and purpose of risk management : What is the definition AND purpose of Risk Management? Explain the steps in the risk management process. Which step is the most important? Identify major and minor loss exposures.
Outline and explain the purpose and potential benefits : Outline and explain the purpose and potential benefits of standard cost systems and variance analysis. (To gain marks your discussion must not simply be a restatement of the Horngren text).
What percent of american adults sleep : What percent of American adults sleep more than 8 hours on weekdays? What percent of American adults sleep less than 6 hours on weekdays? What percent of American adults sleep between 6 to 8 hours on weekdays?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the final charge on the capacitor plates

A 3.0 μF capacitor is charged to 40 V and a 5.0 μF capacitor charged to 18 V are connected to each other, with the positive plate of each connected to the negative plate of the other. What is the final charge on the 3.0 μF capacitor

  Derive the transfer function for a system with an function u

Derive the transfer function for a system with an function u(t) and an output function x(t) described by the following differential equation; d^3x/d^5d^2x/dt^2+17d^x/dt+13=d^2u/dt+6

  Compare input sequences on two inputs of sequential circuits

A sequential circuit has two inputs, w1 and w2, and an output z. Its function is to compare the input sequences on the two inputs. If w1 = w2 during any four consecutive clock cycles, the circuit produces z=1; otherwise, z=0. For example

  Write about summing type and difference amplifiers

Write about summing type and difference amplifiers?

  Find rms power when emf freq is given

In a circuit, the generator voltage varies in time, where the amplitude of e max= 1.2 volt and emf freq.= 0.5 Hz , which the max current is equal to the max current when the freq. of emf = 3.0 Hz, which is .00033 A.

  What is the power factor of the current supplied

Two one phase loads, a 5kW resistor, and a 10kVA load with a 0.707 lagging power factor are connected in parallel to a 120 V source. What is The power factor of the current supplied to the two loads by the source

  What are the output frequency and duty cycle

Write the VHDL ARCHITECTURE file for the Y(5) output only for a 8-to-1 demultiplexer. The inputs are D, the selects S0-S2, and the outputs Y(0)-Y(7). The select lines are BIT_VECTOR types, the data is BIT type and the outputs are BIT_VECTOR types.

  Question 1the linear circuit shown above consists of

question 1the linear circuit shown above consists of dependent sources and resistors only. if the value of the voltage

  What information is possibly being transmitted

Drift velocity the actual (physical) velocity of electrons along the wire. Transmission velocity the rate at which information can be transmitted electronically using conducing wires. How is it possible that the transmission velocity is so much faste..

  How much energy is absorbed by the eardrum in minutes

A sound wave with an intensity level of 80.9 dB is incident on an eardrum of area 6.00 times 10-5 m2. How much energy is absorbed by the eardrum in 3.0 minutes

  What would the probability become if the temperature rises

For a conductive metal the Fermi energy was determined to be 7.01eV at 300K. a)What is the probability of an electron occupying the energy level of 7.15eV b)What would the probability become if the temperature rises to 757°C

  Determine the current-power and energy of the capacitor

A 10-uF capacitor has a voltage with the followingtime dependence: v(t)=20*[1-exp(-5*t)] in unit of Volt. Determine the current, power, and energy of the capacitor as a function of time.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd