Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Three single-phase transformer are used to form a three-phase transformer bank rated 13.8kV(delta)/120kV(wye). One side is connected to a three-phase load of 12 MVA at 0.8 power factor lagging. Determine the turns ratio of each transformer and the current of the bank at the 120 kV side.
The (uniform) area density of defects for a CMOS fabrication process is 0.1 cm-2. Estimate the yield for integrated circuits with the following dimension: 4mm x 4mm, 6mm x 8mm, and 9mm x 12mm.
What is the power level entering the first active stage of the receiver at 1900 MHz being fed by a 25 meter coax with a loss of 20 dB/km, given that the Isotropic Receive Level is -134 dBW and the receiving station has a 1 meter radius dish
1. draw a pair of concentric circles. the radius of a smaller circle has to be 40% as large as the radius of the other circle. you decide to make the radius of the smaller circle 5". what would be the circumference of the larger circle approximat..
Design a 16 bit adder using both the ripple carry and CLA methods. Use 4-bit CLA blocks for the carry-lookahead design. Use only two-input logic gates in your design. Simulate the design using LogiSim at the logic gate level.
Consider a unity feedback control system with plant transfer function G(s) and controller transfer function Gc(s). (a) If the phase margin and crossover frequency are adequate but you need to increase the error constant.
Design a sequential circuit with input x and output Z. The circuit outputs 1 whenever the input "1100" arrives. For example, the following sequence Z is generated as a result of the following input x
A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source. Calculate (a) the average and reactive powers delivered to the load, (b) the peak current, and (c) the load impedance.
What is the total power density and total available current density between wavelength of 280 and 1240 nm for the AM0 and AM1.5 spectra. Assume each photon generates on electron-hole pair. You will need AM1.5 and AM1.0 spectra.
Determine the energy uses on farms in middle east and determine whether or not it is better to use a stand alone system or a grid connected system for the application on farms.
What are the two possible frequencies to which the local oscillator could be set? What bandwidth should the 10.7 MHz IF amplifier have?
The purpose of this project is to design a device that would remotely control (from a Bluetooth-enabled mobile phone for instance) at least two actuators (e.g. relays and switches).
A binary data stream needs to be transmitted at 5 Mbit/s by means of binary signaling. To reduce ISI, a cosine roll-off pulse of roll-factor r = 0.25 will be used. Determine the minimum required bandwidth for this transmission
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd