Determine the total current in each line of 3-phase motor

Assignment Help Electrical Engineering
Reference no: EM13229623

Three -phase motor is connected to a three-phase power source that has an abc phase sequence. the first load is a wye-connected, three-phase motor withdrawing a line current of 20A at a 0.8 lagging power factor. the secound load is a single-phase load between lines a and b of the three-phase power line, determine the total current in each line.

Reference no: EM13229623

Questions Cloud

Determine the frequencies of aliasing noise : a. Sketch the spectrum of the original signal and the sampled signal from 0 kHz and 25 kHz. b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal.
Explain the mass of carbon fixed by photosynthesis : The total surface area of the earth consisting of forest, cultivated land, grassland, and desert is 1.49 x 108 km2 . Every year, the mass of carbon fixed by photosynthesis by vegetation covering this land surface according to the reaction 6CO2
Sketch the spectrum of the original signal nd sampled signal : a. Sketch the spectrum of the original signal and the sampled signal from 0 kHz and 25 kHz. b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal. X(f) 10k 2..
Explain standardizes naoh titrant solution with khp : A student standardizes his NaOH titrant solution with KHP. He performs three titrations - in each trial, the mass of KHP (204.22 g/mol) used is 1.500 g. The average amount of NaOH used in the standardization is 29.3 mL +/- 0.06 mL.
Determine the total current in each line of 3-phase motor : Three -phase motor is connected to a three-phase power source that has an abc phase sequence. the first load is a wye-connected, three-phase motor withdrawing a line current of 20A at a 0.8 lagging power factor.
Depict a hypothetical titration curve and label the points : Draw a hypothetical titration curve and label the points where .5 equivalents, 1.0 equivalents, 1.5 equivalents, and 2.0 equivalents of base have been added. What is the relative concentration of [H2A], [HA-], and [A2-] at each of those points?
Determine the phase currents iab-ibc and ica of the load : A balacnced, three-phase, delta-connected load is supplied by a balanced, three-phase, wye-connected source over a balanced three-phase line. the source voltages are in abc phase sequence in which Van is 19.94
Explain phenolphthalein is an acid base indicator : Phenolphthalein is an acid base indicator. What color does it possess in the presence of excess hydrogen (i.e., hydronium) ions?
Explain sample of a ternary mixture composed : Consider a 15.0 mL sample of a ternary mixture composed of 25% (by volume) octane, 35% chloroform and 40% 2-propanol. Use the following information to convert volume composition to molar composition:

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Saw on internet some equations to convert from frequency

Saw on internet some equations to convert from frequency in hertz to mph. Some equations need a gear ratio while others do not. I found the equation mph = circumference * RPM * 60.

  What is bit rate of the transmission on the twisted pair

What is bit rate of the transmission on the twisted pair? If the digital outputs of three identical video cameras are combined onto a single cable using time division multiplexing, what is the bit rate on the cable?

  Determine the minimum order of the filter at sampling rate

the -3 dB frequency for low pass Butterworth filter is 2.5 kHz. The stop band begins at 3.8 kHz, with an attention of 35 dB. Determine the minimum order of the filter if the sampling rate is 8 kHz

  Find the treanstion width if the order of the filter

A design for high pass filter with butterworth characteristic is needed. Filter specification rewquire a cut-off frequency of 9 kHz for a sampling rate of 44 kHz, and a stop band attenuation of 40dB

  Report changes on primavera

Can you write a part of project which is about developing a schedule of power substation on primavera (P6), focusing on the Changes that will happen based on the following:

  Sketch the spectrum

sketch the spectrum

  Sketch the dft

Sketch the DFT(discrete fourier transform)for a square wave with frequency 1Hz and 10 Hz given N=64 and SR(sample rate)=128. Make sure to label your axes.

  Determine a suitable sampling frequency

Determine a suitable sampling frequency. Design a notch filter to remove the 50Hz component, paying particular attention to any assumptions you have made in the design.

  Calculate the rectangular form of the four-point dft

Compute the rectangular form of the four-point DFT of the following signal, which is zero for n =4. Compute the inverse DTFT of: X(ω)=sinΩ cosΩ

  Find a possible series rl circuit equivalent to n

Find a possible series RL circuit equivalent to N.

  Calculate the ohmic value and power of the series resistor

A 250hp, 500v dc shunt motor draws a nominal field current of 5A under rated load. The resistance is 90ohms. Calculate the ohmic value and power of the series resistor needed so that the field current drops to 4.5A

  Create a cron file that will regularly perform

Create a cron file that will regularly perform the following backups:?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd