Determine the total charge flowing into a element

Assignment Help Electrical Engineering
Reference no: EM13262657

1. The power contained in a sinusoidal current signal with an amplitude of 6 and a frequency of 6 Hz flowing through a resistance of 1 ohm is:
A. 36 watts
b. 18 volts squared seconds
c. 36 ampere squared seconds
d. 18 watts

2. Given v1= 20sin(wt+60) and v2= 60 cos(wt-10), determine the phase angle between the two sinusoids and which one lags the other.
a. 60 and v1 lags v2
b. 20 and v1 lags v2
c. 20 and v1 leads v2
d. 60 and v1 leads v2

3. which statement does not describe a sequential circuit?
a. a circuit composed of a combinational circuit with added memory.
b. the output values depend only on the present value of the inputs and not on past values.
c. a circuit that is said to have memory
d. none of the above

4. if x[n] = uu[n+4] -4u[n] +3u[n-3], then x[2] is
a. 0
b. -1
c.-2
d.-3

5. Determine the total charge flowing into a element for 0< t< 2s when the current entering its positive terminal is i(t) = exp (-2t) mA.
a. 490 uf
b. 500 uf
c. 450 uf
d. None of the above

6. The Taylor series are used to estimat f(x) = e^-12x , at xi +1, for f(1) =0.312 , and f(0.25) = 0.7408
a. 0%
b. 70.21
c. 145.95%
d. 10.11%

7. One root of the equation 3X^2 -X - 2 = 0 is
a. -1
b. -0.667
c. 0.937
d. 0.826

8. The real root of f(x) = 2(e^x - 2x^3)
a. [0 0.5]
b. [1.2 1.6]
c. [1.7 4]
d. [0.8 1.4]

Reference no: EM13262657

Questions Cloud

What price would an investor be expected to pay : If the current price of the stock is $18.90, and the equity cost of capital for the company that released the shares is 6.4%, what price would an investor be expected to pay per share five years in the future?
What is the merry-go-rounds angular velocity : A merry-go-round is a common piece of playground equipment. A 3.0-m-diameter merry-go-round with a mass of 230kg is spinning at 17rpm, What is the merry-go-round's angular velocity, in rpm, after John jumps on
Explain oxidizing agents that are capable of oxidizing : With which of the metals Cu(s), Al(s), Ag(s), Fe(s) and Zn(s) is reaction with H+(aq) ions to produce H2(g) a spontaneous reaction. Select three oxidizing agents that are capable of oxidizing Cl-(aq) ions to Cl2(g)
Define and explain unbiased predictor : Define and explain "unbiased predictor" in terms of how the forward rate performs in estimating future spot exchange rates?
Determine the total charge flowing into a element : Determine the total charge flowing into a element for 0
What is her new rotation frequency : A 45kg figure skater is spinning on the toes of her skates at 1.2rev/s . Her arms are outstretched as far as they will go. What is her new rotation frequency, in revolutions per second
Explain combining aqueous solutions of bai2 and na2so4 : Combining aqueous solutions of BaI2 and Na2SO4 gives a precipitate. Which ion(s) is/are spectator ions in the reaction
How fast is galaxy moving : Galaxy A is moving away from us with a speed of 0.80c relative to the earth. How fast is galaxy A moving according to an observer in galaxy B
Find what output power is required from the modulator : An amplitude modulated amplifier has a radio frequency output of 50w at 100% modulation. The internal loss in the modulator is low. What output power is required from the modulator.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Describe what is the mass of licl in a unit cell

Lithium chloride crystallizes in a face-centered cubic structure. The unit cell length is 5.14 10-8 cm. The chloride ions are touching each other along the face diagonal of the unit cell. The lithium ions fit into the holes between the chloride io..

  Find synchronous motor current and excitation line current

A 460-V, three-phase,60-Hz system supplies power to a 10-kVA, delta-connected resistor load; a 50-kVA, 0.86 power factor induction motor, and a wye-connected synchronous motor that is operating at 0.62 power factor leading

  Determine the frequency response function of the low-pass

design a 4th order Butterworth band-pass filter, using a low-pass filter followed by a high-pass filter, to extract the 1200Hz and 1500Hz components from the signal x(t) a. Determine the cut-off frequencies of the low-pass and the high-pass filters..

  Determine the line impedance of three-phase wye-wye system

In a balanced three-phase wye-wye system, the load impedance is 10+j10 ohm. The source has phase sequence abc and the line voltage Vab= 220

  Determine the electric and potential in dielectric region

The upper and lower conducting plates of a large parallel-plate capacitor are separated by a distanced and maintained at potentials V0 and 0, respectively. A dielectric slab of dielectric constant 6.0

  Find total complex power absorbed by the wye-connected load

A tree-phase, 60Hz, 5MVA synchronous generator has balanced line-to-line voltages of 8320V at its terminals. if the generator is supplying power to delta-connected, balanced load of 5MVA at a 0.8 lagging power factor

  Determine the nominal value and the maximum tolerance

a resistor is required for an application that requires its value to be no less than 7.1k ohms and not more than 7.9k ohms. determine the nominal value and the maximum tolerance of the resistor you could use. explain.

  Find the average force on the ball from the players foot

A soccer player kicks a soccer ball of mass 0.45 kg that is initially at rest. The player's foot is in contact with the ball for 1.1 x 10-3 s, and the force of the kick is given by F(t) = [(6.1 x 105)t - (2.3 x 108)t2] N for 0 t 1.1 x 10-3s, where ..

  Determine the voltage profile in the device

A p-n junction is made by doping Silicon with donors and acceptors. The doping at the p side has a uniform density of NA, but the doping density at the n side is not uniform and changes linearly with the distance from the metallurigical junction.

  Find voltage regulation for load at leading power factor

A 3 phase Y connected alternator is rated at 1600 KVA, 13500 V. The armature resistance and synchronous reactance are 1.5 ohms and 30 ohms respectively. Calculate the % voltage regulation for a load of 1280 KW at 0.8 leading power factor.

  Find force f on current element assuming b field constant

A current element of length 1cm is located at (1m, 3m, 4m) in free space and carries a current of 20mA along ay. An infinitely long filamentary current of 12A along az passes through the coordinate origin (0,0).

  Explain how long will the cassette tape player operate

How long will the cassette tape player operate at normal power? A walker's cassette tape player uses 4 AA batteries in series to provide 6V to the player circuit.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd