Determine the thermal resistance in si units

Assignment Help Physics

Reference no: EM13550098

The R factor for housing insulation gives the thermal resistance in units of ft2 °F h/BTU. A good wall for harsh climates, corresponding to about 10 in of fiberglass, has R = 40 ft2 °F h/BTU. (a) Determine the thermal resistance in SI units. m2 K/W (b) Find the heat flow per square meter through a wall that has insulation with an R factor of 40, with an outside temperature of ?33 °C and an inside temperature of 20 °C. W/m^2

Reference no: EM13550098

Questions Cloud

What is the value of the earths magnetic field : A 512-turn circular-loop coil with a diam- eter of 17.4 cm is initially aligned so that its plane is perpendicular to the Earth’s mag- netic field. In 2.46 ms the coil is rotated 90.0? so that its plane is parallel to the Earth’s magnetic field. An a..

Explain how many moles of benzoic acid use in reaction : How many moles of benzoic acid did you use in this reaction. How many moles of methanol did you use. Why was this particular molar ratio of reactants chosen

Obtain the extra force the sprinter must exert on the ground : A sprinter of mass 71.4 kg runs at a constant speed of 11.1 m/s in a straight line. Find the extra force the sprinter must exert on the ground to round a curve of radius 10.3 m

Estimate the factor of safety of the slope against sliding : Estimate the factor of safety of the slope against sliding. Use the table on page 2 as a design guide.

Determine the thermal resistance in si units : The R factor for housing insulation gives the thermal resistance in units of ft2 °F h/BTU. A good wall for harsh climates, corresponding to about 10 in of fiberglass, has R = 40 ft2 °F h/BTU.

Calculate the minimum acceleration of the car : A small package rests on the horizontal dashboard of a car. If ?s = 0.340, what is the minimum acceleration of the car that will cause the package to slip off

Estimate how large must this force be : You are holding a bulletin board weighing 8.68 N in place against a wall while your friend secures it to the wall. How large must this force be if the coefficient of static friction with the wall is 0.42

Explain chromium for atomic absorption spectroscopy : An unknown Chromium solution was mixed with aliquots of a standard solution of Chromium for atomic absorption spectroscopy. The standard solution contained 1000 ppm of Chromium (this is [s]i)

Explain the absorbance of this mixture at the mn wavelength : The absorbance of this mixture at the Mn wavelength was 0.128 and the absorbance at the Fe wavelength was 0.128. Find the concentration of the unknown Fe solution. (Note: In AAS each element is detected at its specific absorption wavelength)

User Account

All Pages