Determine the tension in the cable

Assignment Help Mechanical Engineering
Reference no: EM13701029

A 8 m rectangular gate shown below weighing 200 N is held in place by a horizontal flexible cable as shown in the figure below. Water acts against the gate which is hinged (frictionless hinge) at point A. determine the tension in the cable.

Reference no: EM13701029

Questions Cloud

The rate of entropy production in the heating elements : At steady state, a 750 W electric resistance heater has an outer surface temperature of 450 degrees C on its heating elements. Find the rate of heat transfer from the heater as well as the rate of entropy production in the heating elements
Find relative humidity at outlet and amount of water added : Air at 40 °C, 1 bar, and 10% RH goes through an evaporative cooler, and the outlet air is cooled to 27 °C. Find (a) the relative humidity at the outlet, and (b) the amount of water added (kg H20 per kg of air).
Find the final relative humidity and rate of heat transfer : Outside air at 1 bar, 5 °C and RH 70% is heated to 25 °C. The flow rate of air is 50 m 3/min. Find (a) the final relative humidity, (b) the rate of heat transfer (in kW) needed to heat up the air?
Velocity profile from the navier-stocks equations : I need to be able to derive the velocity profile from the navier-stocks equations. Basically from scratch. Problem 4.36 in the fluid mechanics seventh edition Frank M. White In need to get derived down to the Differential form and find the constant o..
Determine the tension in the cable : A 8 m rectangular gate shown below weighing 200 N is held in place by a horizontal flexible cable as shown in the figure below. Water acts against the gate which is hinged (frictionless hinge) at point A. determine the tension in the cable.
An escape artist is chained and placed : An escape artist is chained and placed in a 1 m x 1 m x 2 m box in which one side is hinged at the top of the box. The box is lowered into water until the top surface is just below the water surface. At that point, an 8 cm diameter hole is opened 0.7..
Where are the respective reference points of particles : Two particles A and B start from rest at the origin s=0 and move along a straight line such that a_A=(6t - 3) ft/s^2 and a_B=(12t^2 - 8) ft/s^2, where t is in seconds. Where are the respective reference points of particles A and B? What are the direc..
Using constant specific heats at room temperature : A closed gas turbine unit uses neon as the working fluid. There are two stages of compression with inter cooling from 480kPa and 290K to a maximum pressure of 2.75MPa with an intermediate pressure of 1149kPa. The regenerator has an effectiveness of 6..
For an adiabatic in viscid flow : For an adiabatic in viscid flow, write the entropy equation in general coordinate-independent form and in Cartesian coordinates. What does the equation express? Can we say that entropy is constant in an entire such flow (explain your answer)?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A 07-lb block rests on top of a 05-lb block supported by

a 0.7-lb block rests on top of a 0.5-lb block supported by but not attached to a spring of constant 9 lbft. the upper

  Calculates and displays the reaction and member forces

Determines if the member forces are in tension or compression (note that a negative number denotes compression and a position number denotes tension)

  Refrigerant 134a is compressed at steady state from 24 bar

refrigerant 134a is compressed at steady state from 2.4 bar 0oc to 12 bar 50oc. refrigerant enters the compressor with

  The rod is in an air environment with tinfinity25c and h30

a brass rod k 133 wmk 150mm long and 10mm in diameter extends horizontally from a casting at 200 c. the rod is in an

  Find the final mass of air

A balloon behaves so the pressure is P = C2V1/3, C2 = 100 kPa/m. The balloon is blown up with air from a starting volume of 1 m3 to a volume of 3 m3. Find the final mass of air assuming it is at 25oC and the work done by the air.

  At this state the piston is 01 m from the cylinder bottom

saturated water vapor at 200 kpa is in a constant-pressurepiston cylinder assembly. at this state the piston is 0.1 m

  For the given chemical reaction calculate the net effect

for the given chemical reaction calculate the net effect due to changing from the standard state at 298 k to 2 bar and

  If the outside heat transfer coefficient is approximately 5

a small kiln for firing ceramic products has inside dimensions 1 m wide 1 m high and 1.5 m deep. the walls are 50 cm

  Velocity and radius of curvature

Strategy formulation presupposes a set of objectives and goals.

  If the heat transfer coefficient between the lagging and

a chemical reaction takes place in a spherical pressure vessel. the rate of heat release per unit volume from the

  Assuming that the engine is made of iron and has an average

the combustion chamber of an internal combustion engine is at a temperature of 1100degc when fuel is burned in the

  A 075 m3 tank contains nitrogen at 150kpa and 40degc 20 kg

a 0.75 m3 tank contains nitrogen at 150kpa and 40degc. 2.0 kg of oxygen are added to the tank. what is the final

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd