Determine the tension in each of the cables at a time when

Reference no: EM13546688

A long trough is supported by a hinge along its lower edge and a series of horizontal cables attached to its upper edge. Determine the tension in each of the cables, at a time when the trough is full of water. Ther are 4 cables, each one is 20 inches apart. The radius of the trough is 24 inches. The specific weight of water is 62.4 lb/ft^3

Reference no: EM13546688

Questions Cloud

Prepare the t-accounts and journal entries : Prepare the T-accounts for raw materials inventory, work in process inventory, finished goods inventory, manufacturing overhead, and cost of goods sold. Don't forget to enter the beginning balances in the inventory accounts.

The pump is located close to the pipe entrance at the lower : Water from a lower reservoir (water surface elevation) 500 m is pumping to the upper reservoir (water surface elevation 600 m) through a 5000 m long straight pipe with 0.5 m diameter

Calculate the distance the tank has moved when the water in : Use appropriate kinematics equations (for the right ranges) for the new velocity and distance traveled. (Hint: when the impulse becomes a non-negative number set it to zero; then the acceleration becomes zero and the velocity does not change; so use ..

Why was the specific weight of water used to find the head : A beam must carry a total factored bending moment of 1062kN-m. It has a maximum beam effective depth of 25in. Design the beam in US customary units using f’c=4ksi and fy=413.4MPa. If necessary use d’=2.5in. Assume an exterior exposure according to AC..

Determine the tension in each of the cables at a time when : A long trough is supported by a hinge along its lower edge and a series of horizontal cables attached to its upper edge. Determine the tension in each of the cables, at a time when the trough is full of water.

Determine the design speed of the curve : An egual-tangent sag vertical curve is designed with the PVC at station 109+00 and elevation 950 ft, the PVI at station 110+77 and elevation 947.34 ft, and the low point at station 110+50. Determine the design speed of the curve.

The column bearing is 12 in. measured along the beam : A W24X94 beam on a 6 ft span underpins a column that brings 110 kips dead load and 280 kips live load to its top flange at a location 2.5 ft from the left support.

Find the discharge with an risk of being equaled or exceed : Find the discharge with an 80% risk of being equaled or exceeded at least once in the next 10 years. (Hint: first find the annual probability of exceedance for this discharge.)

Compute the ratio of the nominal flexural strength of the : Compute the ratio of the nominal flexural strength of the beam to the maximum service load moment, and compare your findings to the ACI load factors and strength reduction factor.

User Account

All Pages