Determine the temperature at the exit of each turbine

Assignment Help Mechanical Engineering

Reference no: EM13720667

Steam enters a two-stage adiabatic turbine at 8 MPa and 550ºC (State 1) and is expanded to 2 MPa (State 2) in the first stage of expansion. This steam is reheated at constant pressure to 550ºC (State 3) before entering the second stage of expansion. Steam leaves the second turbine stage at 150 kPa (State 4). The power output of the two-stage turbine is 80 MW and isentropic efficiency of each turbine stage is 84%.

a) Calculate the mass flow rate (kg/s) through the two-stage turbine.

b) Determine the temperature (ºC) at the exit of each turbine.

c) Calculate the rate of entropy generation (kW/K) for the two-stage turbine.

Reference no: EM13720667

Questions Cloud

Estimate the concentration and the mass emission rate : Estimate the concentration (in ppm) and the mass emission rate of NOx (in kg/hr, expressed as NO) if a coal containing 1.5% nitrogen is combusted at 1400 K using an air/fuel ratio that is 1.5 times the stoichiometric ratio.

Coal-fired power plant is burning coal with a heating value : A 500 MW coal-fired power plant is burning coal with a heating value of 12,000 Btu/lb. The coal contains 2.0% sulphur. The plant has a thermal efficiency of 38%, and uses an air/fuel ratio of 14:1 (mass basis).

Calculate the required control efficiency : An alcohol manufacturing facility emits air with 500 ppm ethanol. The air flows out several roof vents at a total flow rate of 1000 m³/min (at 25 ° C and 1 atm). The facility is required to collect all the vented air and route it to a bio filter to c..

Determine the true strain at the onset of necking : Assume that for a tensile test, d?t/d?t= ?t when necking begins. Based on this condition, determine the true strain at the onset of necking? Explain carefully any assumptions made.

Determine the temperature at the exit of each turbine : Steam enters a two-stage adiabatic turbine at 8 MPa and 550ºC (State 1) and is expanded to 2 MPa (State 2) in the first stage of expansion. This steam is reheated at constant pressure to 550ºC (State 3) before entering the second stage of expansion.

What is the fracture toughness : A tensile sample of width 10mm contains an internal crack of length 0.3mm. When loaded in tension the crack suddenly propagates when the stress reaches 450 MPa. What is the fracture toughness K1c of the material of the sample? If the material has a m..

Determine the work and heat transfer per unit mass : Water, initially a saturated vapor at 150 degrees Celsius, is contained in a piston-cylinder assembly. The water undergoes a polytrophic process (n=1) to a pressure of 0.01 MPa, during which the piston moves freely in the cylinder.

Phase diagram for a new binary alloy : A “friend” asks you to construct the phase diagram for a new binary alloy of A and B. The clues are: (i) A and B are completely immiscible in each other and no solid solutions exist in the diagram, (ii) no stoichiometric compounds exist in the diagra..

Developed a device that converts heat transferred : An inventor claims to have developed a device that converts heat transferred to it at 1500 degrees Fahrenheit into work with a thermal efficiency of 70%. Heat is rejected to the 70 degree Fahrenheit surroundings. Is this possible? Why or Why not?

User Account

All Pages