Determine the stresses in cables and deflections of points

Assignment Help Civil Engineering
Reference no: EM13319315

The steel beam ABCD is simply supported at A (pin) and supported at B and D by steel cables each having a diameter of 12mm. A force of 20 kN is applied at point C. For steel, let E = 209 GPa. Determine the stresses in the cables and the deflections of points B, C, and D if (a) beam ABCD is considered rigid and (b) beam ABCD has I = 8(10^5) mm^4. Points A, B, C, and D are all on the beam and are 500mm apart. The lengths of cables B and D is 1m.

Reference no: EM13319315

Questions Cloud

Explain what happens to kp when the temperature is increased : Suppose the reaction is at equilibrium 2NOBr (g) 2NO(g)+Br2(g) Delta Hf NOBr=82.2 Kj/mol DeltaHf NO=90.4 KJ/mol What happens to Kp when the temperature is increased
Estimate the amount of depression storage in 6-arce parking : Estimate the amount of depression storage (inches and cubic feet) in a 6-arce parking lot using the following rainfall and discharge data. The discharge data were measured at the only outlet in the parking lot.
Compute the allowable load on a column with fixed ends : compute the allowable load on a column with fixed ends if it is 5.45 meters long and made from an S150 x 18.6(S6 x 12.5) beam. The material is ASTM A36 steel. Use the AISC formula.
Define what is the population ratio when temperature goes up : The frequency of the absorption from the ground to the excited state is 2885 cm-1. What is the population ratio when temperature goes up to 50 oC
Determine the stresses in cables and deflections of points : The steel beam ABCD is simply supported at A (pin) and supported at B and D by steel cables each having a diameter of 12mm. A force of 20 kN is applied at point C. For steel, let E = 209 GPa.
Explain what is the ka of the unknown acid : when 15.12 ml of 0.1194 M NaOH is added to 25 ml of 0.1264 M HX(an unnknown weak acid),the resulting pH is 5.9 . what is the ka of the unknown acid
Determine what is the illumination on the note pad : A supervisor is sitting at her desk illuminated by a 180 candela source 3 feet above it. She is writing with green ink (reflectance=30%) on a yellow note pad (reflectance=60%). What is the illumination on the note pad
Explain the molar concentration of al in the solution : The concentration of SO4 is .5 M in a certain solution of Al2(SO4)3. what is the molar concentration of Al in the solution
Determine the nominal cross-sectional dimensions for douglas : determine the nominal cross-sectional dimensions for a Douglas fir larch No. 1 grade beam of least weight that supports a total uniformly distributed load of 12 kip on a simple thirty-two foot span considering loading in shear

Reviews

Write a Review

Civil Engineering Questions & Answers

  Annual power cost of the ro system

Is the system within membrane manufacturer's warranty requirement of maximum flux rate of 14 gfd? What is the annual power cost of the RO system?

  Find the swell and shrinkage and load and shrinkage factors

material (LCY) in 12 yard dump trucks, placing it, and compacting the weight of the soil is 3,750 lb/cu.yd. (30 pts.) (show your calculations) a) Find the Swell and Shrinkage b) Load and Shrinkage Factors

  Determined from the equilibrium data to be percent by mass

a mild steel component in a form of a finite slab with a thickness of 2L=2.5 mm is to be hardened by packing it in a carbonaceous material in a furnace for a predetermined time. the uniform initial carbon concentration of the slab is 0.15 percent ..

  Determine the amount of the energy losses in meters

A rectangular channel carries a discharge of 2.00 m3/sec per meter of channel width over a weir crest that is 1.4 m in height. The energy grade line upstream of the weir measure 2.7 m above the channel bottom.

  Determine station of pvc and pvt and design speed of curve

An equal-tangent crest vertical curve connects a +3.2% and -1.1% grade. The PVI is at station 98+20. Due to drainage considerations, the highest point of the curve is at station 100+79.35.

  Establish a horizontal distance

a tape is calibrated and found to measure 100.04ft between the 0- and 100-ft marks. what measurements should be laid out to establish a horizontal distance of 682.25ft?

  Find the steel area required for beam

Find the steel area required for beam which has b = 10 in. and d = 17.5 in. to carry a factored load moment of 1,600 in-kips.

  Estimate the peak flood tidal flow velocity at the location

As a tide enters a river and propagates upstream, the water depth at a given location is 3.7m . At this location the tide range is 1m . If the dominant tidal compeonent has a period of 12.4 hours, estimate the peak flood tidal flow velocity at thi..

  Mixed liquor volatile suspended solids

For a mixed liquor volatile suspended solids (MLVSS) of 1800 mg/L, what is the total return solids flow rate?

  Would recycle of return sludge increase the sludge age

if the sludge concentration in the return sludge line from the secondary clarifier were the same as the MLVSS concentration.WOULD recycle of return sludge increase the sludge age why

  Determine water pressure-pressure head and elevation head

For each of the two cases below, determine the water pressure, pressure head, elevation head, and total head at points A, B, and C. Please solve the problem using: (a) the upper reservoir level as the datum

  Determine the distance x and the magnitude and direction

the three forces of magnitude P can be replaced by a single, equivalent force R acting at point A. Determine the distance x and the magnitude and direction of R

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd