Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
As an example the problem of a load on an L-shaped region is considered, see Figure 29.4. On the short leg the load is 15 kPa, on the larger leg the load is 5 kPa. The problem is to determine the vertical normal stress at a depth of 8 m below the point A. The first step in the solution is to draw the loaded area on such a scale that the reference length z in Newmark's diagram corresponds to 8 m, see Figure 29.5, and such that the point A is located in the origin of the circles. The short leg of the loaded area now covers about 7 rectangles, and the long leg covers about 34 rectangles. This means that the stress is
In order to determine the stress at a greater depth, say at a depth of 16 m, the loaded area should be drawn half as large. This then covers a smaller number of rectangles, so that the stress will be smaller.
you are designing a converging-diverging nozzle to operate at sea level. the nozzle will be mounted on a glider that
This shows that the equation ∇T = (δT/δx)e1→+(δT/δy)e2→ cannot be used as the analytical definition of the gradient because it gives different results in different coordinate systems
a pure jet engine propels an aircraft at 330 ms through air at 60 kpa and 0 degrees celsius. the inlet diameter of this
A piston cylinder device initially contains compressed liquid water at 20degreesC and 200kPa. It is heated in an isobaric process (process 1) until it contains only saturated liquid. At this point it occupies a volume of 0.0021m3.
Air at 40C flows over a 2m long flat plate with a free stream velocity of 7 m/s. Assume the width of the plate (into the paper) is 0.5m. If the plate is at constant temperature of 100C,
1. Determine the volume change, in ft3, when 1 lb of water, initially saturated liquid, is heated to saturated vapor while pressure remains constant at 1.0, 14.7, 100, and 500, each in lbf/in.2 Comment. 2. For H2O, determine the specified property..
determine the microstructure for eutectoid steel that has undergone the following heat treatment. for each heat
a frictionless piston-cylinder device contains 2 kg of nitrogen at 100 kpa and 300k. the nitrogen is compressed in a
What is the difference between the specific internal energy of a mixture of saturated water liquid and vapor with a quality of 10 percent (x = 0.1) at 200 degrees C and 100 degrees C.
The mass of the tail rotor blades, including their drive system, is 20 kg. Determine the forced response of the tail section when the blades rotate at 1500 rpm.
The gage pressure of the air in the tank shown in Fig P1-73 is measured to be 80 kPa. Determine the differential height h of the mercury column.
Air at the rate of 18 kg/s is drawn into the compressor of a jet engine at 55 kPa and -23oC and is compressed reversibly and adiabatically to 276 kPa. Determine the required power input to the compressor expressed in horsepower.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd