Determine the stress and slenderness ratio

Assignment Help Mechanical Engineering

Reference no: EM13711477

1. A 10 inch long cantilevered beam has a 1” by 1” square cross section. The load at the end of the beam cycles from 0 lbs to 300 lbs. determine the stress.

2. Determine the slenderness ratio and column constant of a 38” long steel column that has a 1.5 inch per side square cross section. The column is made from AISI 1050 CD steel and is pinned on one end and fixed on another.

3. Determine the endurance strength for a 1.5” diameter machined shaft that is made from AISI 1040 CD steel. The shaft is subjected to rotating bending stress and should have a reliability of 99.9%

Reference no: EM13711477

Questions Cloud

Calculate the maximum shear stress for each stress element : A cantilever beam with a 1 in diameter is loaded at the tip with a transverse force of 1000 lb. Figure 2.1 below shows the beam configuration and cross-section with points A at the top, point B at the center and point C at the midpoint between A and ..

Heat exchanger tubes have to be shorter txceed : In a Modified Rankine Cycle used in a power plant in Wichita, KS, a Shell and Heat Exchanger needs to be installed. Water from the turbine at 90 C is cooled to 80 C in a shell-tube HX using 150 kg/s of raw water from Power Plant Lake.

Compute the natural frequency : Consider a model of a building whose base moves as a result of an earthquake. The building can be modeled as a single-degree-of-freedom spring-mass system where the building mass is lumped on top of two beams used to model the walls of the building. ..

What is the resulting strain of the wire when it is used : Company wants to use a 100 m long steel cable to pull an airplane glider. If the glider has a mass of 1000 kg, and assuming the load is given by F=mg = 9800 N, and if the Young’s modulus of steel is 200 GPa (200,000,000,000 Pa), and Poisson’s ratio i..

Determine the stress and slenderness ratio : A 10 inch long cantilevered beam has a 1” by 1” square cross section. The load at the end of the beam cycles from 0 lbs to 300 lbs. determine the stress. Determine the slenderness ratio and column constant of a 38” long steel column that has a 1.5 in..

Piston-cylinder assembly in an air atmosphere : A piston-cylinder assembly in an air atmosphere of p = 1 atm (= 1.013 bar) contains 1 kg of nitrogen. The initial volume of the nitrogen is 1 m^3, and its initial pressure is 1 atm. The side of the cylinder is heated such that the heat transfer to th..

Slowly reduce the frequency to the point of synchronisation : Why do you think it is important, when using a stroboscope, to start at a very high frequency and slowly reduce the frequency to the point of synchronisation?

Gas behaviour and no change in kinetic or potential energy : A closed, rigid tank fitted with a paddle wheel contains 0.1kgof air, initially at 300 K, 0.1MPa. The paddle wheel stirs the air for 20 minutes, with the power input varying with time according to W = -10t, where W is in watts and t is time, in minut..

Determine the heat transfer for both cases : Liquid propanol at 250C is burned with air at the same temperature in an atmospheric pressure combustor operating at steady conditions. Products of combustion are cooled to a temperature of 250C. Enthalpy of formation of liquid propanol = -301,000 kJ..

User Account

All Pages