Determine the stopping sight distance for a 5-lane

Assignment Help Civil Engineering
Reference no: EM13564943

1.Two pipelines of equal length and diameters 15 cm and 10 cm respectively connect two reservoirs such that the pipelines are in parallel. The difference in water levels in the reservoirs is 3 m. If the friction is assume to be equal, the ratio of discharge in the 15 cm diameter pipe to 10 cm diameter pipe is what?

2.Determine the stopping sight distance for a 5-lane, 2-way highway with a 4.5% grade. The wet coefficient of friction is 0.30 and the design speed is 55mph. The road is abutted by an elementary school with considerable pedestrian traffic. Winter weather is often a problem with temperatures getting into negative numbers.

Reference no: EM13564943

Questions Cloud

Compute the crates velocity two seconds after p has been : A crate has a weight of 50 lb and is acted upon by a force having a variable magnitude of P=20t, where p is in pound and t is in seconds. compute the crates velocity two seconds after P has been applied. The crates initial velocity is 3 ft/s down the..
What is the loss of energy through the jump : In a rectangular channel of 12 m width, water flows at a rate of 150 cms. At the end of the channel, there is a horizontal concrete apron of 12 m width, on which the water depth is 3 m. Will a hydraulic jump formed in the channel and why? What is the..
Find the minimum weight of the gate so that it may have : The cylindrical gate of canal headworks, having a diameter of 3m and a length of 6 m, is subjected to water pressure up to its top as shown in the Figure. The gate resisting on the concrete floor of the headworks
Determine the dimensions of the combined footing : We requiere to design combined footing which will support a load of two columns ( the two columns rest on the same footing). The columns are squared, with a width of 12" and are at a distance of 15' from centre to centre. Determine the dimensions of ..
Determine the stopping sight distance for a 5-lane : Two pipelines of equal length and diameters 15 cm and 10 cm respectively connect two reservoirs such that the pipelines are in parallel. The difference in water levels in the reservoirs is 3 m. If the friction is assume to be equal, the ratio of disc..
What is the probable total error in the whole distance : A distance is measured through mountainous terrain and found to be 5182.40 ft. If on the average a plumb bob is used every 50 ft with a probable error of ±0.02 ft, what is the probable total error in the whole distance?
Evaluate what is thevalue of the inductance : A 12.0 V battery is connected inseries with a resistor and an inductor. The series circuit has atime constant of 597 µs, and themaximum current is 302 mA. What is thevalue of the inductance
What is thevertical height between the two climbers : A rock climber throws a small first aid kit to another climberwho is higher up the mountain. what is thevertical height between the two climbers
Determine the probability that the weakest pile of this : When standing 10 feet from the base of a building, you measure that the bottom of a large window is at 45 degrees from the horizontal, while the top of the window is at an angle 60 degrees. How tall is the window?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what is the power delivered to the fluid

Water enters and leaves a pump in pipelines of the same diameter and approximately the same elevation. If the pressure on the inlet side of the pump is 30 kPa and a pressure of 500 kPa is desired for the water leaving the pump

  Why is too much fluoride in drinking water a problem

A chemical mixing basin is to be designed to blend chlorine and treated wastewater. The basin flow is 700 gallons per minute and the basin dimensions are 5 feet by 5 feet by 5 feet water depth.

  Find the axial load and the total change in each cross

A flat bar of cross section 20mm by 70mm elongates 4.0mm in a length of 2.0m as a result of axial load. If the elastic modulus is 199x106 kN/m2 and Poisson's ratio is 0.25 for the material, find the axial load and the total change in each cross secti..

  Determine what is the coefficient of static friction

A block begins to slide down a ramp after being elevated to an angle of 47.5 degrees. What is the coefficient of static friction

  Determine the specific gravity of the liquid of an object

An object which has a volume of 0.18 m^3 requires a force of 265 N to keep it immersed in water. If a force of 157 N is required to keep it immersed in another liquid, find the specific gravity of the liquid

  Determine the magnitude and direction of the components

The beam is subjected to a force F=825 lb in the direction, and is supported by a pin connection at point B and a rope attached through a pin connection at point A. Problem #1: Draw a complete FBD of the beam.

  Calculate the residence time of the treatment cell

Consider a rectangular wastewater treatment cell having a length of 100ft, width of 20ft and depth of 20ft. If the flow into the cell is 50ft^3/min, calculate the residence time of the treatment cell.

  What may be the value of the load to the beams own weight

A high-strength steel simply supported W24 X 76 beam carries a uniformly distributed load over its entire length of 25 ft. (a) If the allowable stress is 33 ksi, what may be the value of the load, in addition to the beam's own weight

  Determine what is the liquid limit of the soil

In a liquid limit test, the moisture contents correspond to 20, 25 and 35 blows are 36% and 20%, 15% respectively. What is the liquid limit of the soil

  What is the normal depth in a 4-foot wide rectangular

What is the normal depth in a 4-foot wide rectangular channel that conveys a discharge of 100 CFS and has a bed slope of 2% with a Manning’s roughness coefficient of 0.025? a).1.3 feet b).2.7 feet c).4.4 feet d).6.2 feet

  Determine void ratio and unit dry weight of soil particles

A 110 cm^3 sample of wet soil has a mass of 106 g and a degree saturation of 100%. When oven-dried, the mass is 81 g. Determine the 1) water content, 2) specific gravity, 3) void ratio, and unit dry weight of soil particles.

  Determine the dimensions of the best cross section

Water is to be transported at a rate of 60,000 gallons/min in uniform flow in an open channel whose surface are lined with clay tile. The bottom slope is 0.0014. Determine the dimensions of the best cross section

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd