Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Question: Consider a MOS transistor configured as a CS stage and operating in saturation. Determine the IP3 and P1dB if the device
(a) follows the square-law behavior, ID ∝ (VGS - VTH)2, or
(b) exhibits field-dependent mobility.
A semi-infinite nonconducting rod is located on the x-axis from x=0 to x=infinity. The rod has a uniform charge per unit length (lamda). Show that the electric field at point P:(0,-R) makes an angle of 45 degrees with the rod
show that the most probable electron energy in the conduction band of a semiconductor is kt2 above the bottom of the
Find the induced voltage across a 50-mH inductor if the current through the coil changes at a rate of 0.1 mA/µs.
Describe the current flow rule in a series circuit. Draw out series circuit and solve for values. The know values are total current is .15 amps, resistor 1 uses 20 watts of power, and resistor 2 uses 12 watts of power
How is a high-quality digital filter produced with DASYLab using the convolution module?vvvvv
To become familiar with computations involving phasors and the complex representation of sinusoidal ac powers, including the effect of power factor (PF) improvement on both the line current and voltage sources.
Determine the range of DC current that can be applied to coil 2 without saturating the core when coil 1 has a steady 10A DC current in the direction that makes the flux flow CW on the ring . The Current at coil 2 has the same direction as the curr..
Chopper circuit has the parameters of a source frequenCy of 150 Hz and an on time of 3 ms. vohage of 90 V, chopper When this chopper drives an inductive load of 1.5 0 and 15 mH, determine the average load current.
Design the minimum-cost circuit and compare its cost with combined costs of two circuits that implement f and g separately. Assume that the input variables are available in both uncomplemented and complemented forms.
Design an excess-2 code converter to drive a seven-segment indicator . the four inputs to the conducter circuit is (A,B,C, andd) represent it in Excess-2 code decimal digit. the inputs aredigits 0-9, so the six unused combinations are dont cares.
Assuming that there is no frequency-dependent component of the load (i.e., D = 0), find the steady-state frequency deviation and the corresponding new generation of each unit. Use 1000 MVA as the p. u. (per-unit) base.
A 480-120 volt, 5kVA, 2-winding transformer is to be used as an autotransformer to supply a 480-volt circuit from a 600-volt source. When tested as a 2-winding transformer at rated load, 0.8 pf lagging, its efficiency is 0.965.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd