Determine the speed of the cubic block down the plane when

Assignment Help Civil Engineering
Reference no: EM13559267

A 30 Kg cubic block, of side length 300 mm, slides down a lubricated plane with a slope of 30? . The lubricant has an absolute viscosity of 2.3x10^-3 N.s/m^2.

Q) Determine the speed of the cubic block down the plane when in equilibrium.Hence determine the total force required to pull the cubic block up the plane at the same speed.

given:

speed of block = 21.32 m/s

Total force to pull block up plane = 181.6 kN

Reference no: EM13559267

Questions Cloud

Is it possible to compute the magnitude of the load : A brass alloy has a yield strength of 280 MPa, a tensile strength of 390 MPa, and an elastic modulus of 105 GPa. A cylindrical specimen of this alloy 12.7 mm in diameter and 250 mm long is stressed in tension and found to elongate
Determine the amount of heat loss by the system : Water flows in a circular pipe of diameter D at a depth y (
Find the temperature of the air after the compression : In a diesel engine, the piston compresses air at 301 K to a volume that is 0.0621 of the original volume, What is the temperature of the air after the compression
Determine the uniform depth in the channel : A clean-earth channel, for which n=0.020, is 6m wide and lies on a slope of 0.005236. Water flows at 30m3/s through the channel and enters a reservoir. The water depth in the channel, just before the entry to reservoir, is 3m.
Determine the speed of the cubic block down the plane when : Determine the speed of the cubic block down the plane when in equilibrium.Hence determine the total force required to pull the cubic block up the plane at the same speed.
Simplify the shape of the base and the 4 legs and estimate : The Statfjord B drilling platform, was built in Norway and towed 370km in 5 days to its present site in the North Sea in August 1981. It is the heaviest object ever moved by man
Evaluate by how much does its volume decrease : The deepest place in all the oceans is the Marianas Trench, wherethe depth is 10.9 km and the pressure is 1.10E+8 Pa, by how much does its volume decrease
Calculate the minimum number of plates using a total : Using a reflux ratio of twice the minimum reflux, calculate the minimum number of plates using a total condenser and reboiler and a Murphree plate efficiency of 65%.
Equilibrium partial pressure of benzene in gas : Benzene is to be absorbed from coal gas by means of a wash oil. The inlet gas contains 3% by volume of benzene, and the exit gas should not contain more than 0.02% benzene by volume. The suggested oil circulation rate is 5 kg oil per 1m3 of inlet gas..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the ntu values for each sampling port depth

The packed tower was 30 cm in diameter with sampling ports located at packing depths of 0,2,4,6,8,10, and 12 meters. The loading of water to the tower was 0.039 m^3/(m^2/s), and the temperature of groundwater was 10 degrees celcius.

  Compute the range in h corresponding to range in pressure

Compute the height (h) of the water tank above theground surface to provide a static pressure of 75 psi. Compute the pressure at a point in a building that is 40 feet abovethe ground surface.

  Determine the students final angular velocity

This causes the student to begin to rotate. Find the student's final angular velocity. The moments of inertia of the wheel and of the student are 0.313 kg · m2 and 2.09 kg · m2 respectively.

  Determine what is the shear stress at the pipe wall

Stream with a specific weight of 38 N/m^3 is flowing with a velocity of 35 m/s through a circular pipe with f=0.0154. What is the shear stress at the pipe wall

  Draw the event tree and for the initiating event

An intelligence data bank center requires power 24 hours a day, 7days a week. If the main power grid fails, a backup power supply isinitiated.

  Fresh water fish do not survive in water

If the concentration of glucose in plasma is 5 mM, and theintracellular glucose concentration is negligible (i.e. 0 mM), whatis the rate of glucose diffusion (J) into the cell? Assume that thethickness of the plasma membrane is 10 nm.

  Determine the water depth at 30 m upstream of the brink

The channel entrance is rounded and smooth (negligible head loss at entrance), and the reservoir water surface is 2.5 m above the bed of the channel at the entrance. hf=0.00019*Q2, where Q (in m3/s) is the discharge in the channel.

  What is the thickness of the viscous sublayer

The influent BOD5to a primary settling tank is 345 mg/L.The average flow rate is 0.050 m3/s.If the BOD5 removal efficiency is 30%,How many kg of BOD5 are removed in the primary settling tank each day?

  What is the reliability of the system

A water pipeline system is made up of three links in parallel. In any given year, on average, 99 in 100 pumps do not fail. The conditions in the links are statistically independent of each other.

  What is friction of k and how does it work into the reaction

A 400 lb crate is on a 20 degree incline. If a 120 lb horizontal force (P), pushes on the crate (upwards), determine the normal and frictional forces acting on the crate. Take friction of surface = 0.3 and friction of k = 0.2?

  Determine the gauge pressure head and the absolute pressure

A vertical tank of 4.sm2 cross-sectional area is filled with 13.5m3 of water, 9.0m3 0f a fluid with an s.G. of 3.2,6.75;. or oir with an s.G. of 0.85 and 0.9m3 of mercury with an s.G. of 13.s7.

  How many of the incinerators in chicago meet the standard

Stack gas samples were collected from a sample of 50 incinerators in Chicago. Of the 50 samples, only 18 met an environmental standard for the concentration of a hazardous compound. Can it be concluded that fewer than half of the incinerators in C..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd