Determine the size of the watershed in acres and then

Assignment Help Civil Engineering
Reference no: EM13545658

The 1-hr UH in the table was recorded for a particular watershed. Determine the size of the watershed in acres and then convert the 1-hr UH into a 3-hr UH for the watershed.

Time (hr) 0 1 2 3 4 5 6 7 8 9 10

U (cfs) 0 6 22 48 80 65 50 30 18 5 0

Reference no: EM13545658

Questions Cloud

What major differences would you expect if the water supply : A large stream flowing through a highly industrialized area must serve as the source of a community's water supply. The turbidity of the water ranges from 30 to 60 NTU, alkalinity exceeds 100 mg/L.
Determine the coliform concentration at the beach : Determine the coliform concentration at the beach. (assume that the current behaves as a plug flow reactor and that the wastewater is completely mixed in the current at the discharge point.
What is the discharge of each hole : A water of 20 c temprature pupped at 75 kpa to a perforated pipe 5 cm dia. contain 10 hole with the same diameter. the distance between two adjacent hole is 20 cm. what is the discharge of each hole?
Use the conveyance method to verify the results : A drainage channel had a cross section that may be approximated as a trapezoidal section with a bottom width of 15 feet and a side slope of 1.5H:1V. If the channel drops 2.5 feet per mile.
Determine the size of the watershed in acres and then : The 1-hr UH in the table was recorded for a particular watershed. Determine the size of the watershed in acres and then convert the 1-hr UH into a 3-hr UH for the watershed.
Determine the magnitude of the largest elastic load p that : The 10-mm-diameter steel bolt is surrounded by a bronze sleeve. the outer diameter of this sleeve is 20 mm, and its inner diameter is 10 mm. if the yield stress for the steel is
What is the maximum weight of the crate that the system can : Rope BCA passes through a pulley at point C and supports a crate at point A. Rope segment CD supports the pulley and is attached to an eye anchor embedded in a wall. Rope segment BC creates an angle of = 74.0 with the floor and rope segment CD
Find the capacity of the column with 1% reingforcement : A circulatr concrete column with a diameter of 8" has spiral reinforcing. Find the capacity of the column with 1% reingforcement. Find the capacity of the column with 8% reinforcement.
Sketch how you will place the bars and calculate : Concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth. Place as many bars in the lower layers as possible.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Estimate the density of the air at an elevation of 10 km

Titan, a moon of Saturn, is believed by astronomers to have an atmosphere that is about 95% nitrogen. At Titan's surface the acceleration due to gravity is 1.35 m/s2, the atmospheric pressure is 210 kPa, and the temperature is 94 K.

  Under what situation shall engineers use jacking at one end

Sometimes the side of concrete bridges is observed to turn black in colour. What is the reason for this phenomenon? In prestressing work, if more than one wire or strand is included in the same duct, why should all wires/strands be stressed at the sa..

  What supported in the weak direction at the one-third points

The member is 24ft long with pinned end supports and is laterally supported in the weak direction at the one-third points of the total column length. Use 50 ksi steel.

  Is the work on the ball recoverable

A 1kg ball is dropped from the top of a cliff and falls with a constant acceleration due to gravity. Assume that effects of air resistance can be ignored.

  Determine what is the offset at the midpoint on the curve

a vertical curve with grade1= 3.6% meets the exit grade of -4.7% at PVI located at station 26.50. A vertical curve of 700 feet is propsed to provide the transition between the two grades.

  What is its specific gravity at 30 percent moisture content

The cross sectional dimensions of a 4-ft-long wood member at 30% moisture content is 1.5 in. x 7.5 in., and its weight is 11 lb. At oven-dry condition, its dimensions and weight are 1.35 in x 6.8 in., and 10.2, respectively. What is its specific g..

  Calculate how many chlorine atoms will be in an average

Calculate how many chlorine atoms will be in an average neoprene chain? b) Sketch the bonding between polychloroprene chains due to sulfur linkages as neoprene is vulcanized into an elastomer. c) You decide to go swimming in Bear Lake in late Novembe..

  Determine void ratio-porosity and moisture content of soil

A container containing saturated soils weighs 113.27 g before being placed in an oven and 100.06 g after drying remains in the same container overnight. The empty container weighs 49.31 g and relative density of the grains is 2.80.

  What is the future worth of per year of each plan at age 85

Mike and Susan hope to retire a few years early, they decided to pay closer attention to the predicted amount of retirement benefits and do some analyses on the numbers.

  Find the minimum length of runway required for the landing

Find the minimum length of runway required for the landing (I found to be 300ft). Find the position on the runway where the speed is 50ft/s and the time it takes for the speed to reach 50ft/s

  Question 1 what is the difference between labor cost and

question 1. what is the difference between labor cost and labor pro-ductivity? use a sketch to illustrate.question 2.

  Determine the design a typical joint 50mm wide

A floor is to be supported on hardwood timber joists that are spaced at 0.5m centres and span 5.0m. The joists support flooring 20mm thick and an applied live load of 2kN/m2 Design a typical joint 50mm wide

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd