Determine the size of the foundation using factor of safety

Assignment Help Civil Engineering
Reference no: EM132416364

A square foundation with dimension (BxB) has to be constructed on dense sand. Its depth is Df = 1 m. The unit weight and the angle of friction of the soil can be assigned representative values of 18kN/m3 and 39o, respectively. The foundation may be subjected to a maximum dynamic load of 1800 kN increasing at a moderate rate. Determine the size of the foundation using a factor of safety of 3. (Assume kv=0 and kh =0.176).

Reference no: EM132416364

Questions Cloud

Evaluate the wave celerity-length-group celerity : Evaluate the wave celerity, length, group celerity, energy in one wavelength (EL), and power.
Calculate the time required for the absolute pressure : Calculate the time required for the absolute pressure in the tank to decrease from 500 to 400 kPa.
Calculate the reduced level of the intersection point : Calculate the reduced level of the intersection point and the distances from the intersection point to the two points.
How you used critical thinking to set that change in motion : Consider a major change you have already made in your life in order to look back at that process and recognize how you used critical thinking to set that change
Determine the size of the foundation using factor of safety : Determine the size of the foundation using a factor of safety of 3. (Assume kv=0 and kh =0.176).
Write about Comparative Data Bar Graph : IHP 604 Healthcare Quality Improvement Assignment Help and Solution - Southern New Hampshire University, USA. Write about Comparative Data Bar Graph
State legislatures continue to advance policy proposals : State legislatures continue to advance policy proposals to address cyber threats directed at governments and private businesses
What is the shear strength t of the soil : What is the shear strength t of the soil in kPa at this state? Please answer the following question.
What is the theoretical inclination of the shear zone : What is the theoretical inclination of the shear zone with respect to the horizontal within a cylindrical sample at failure in a triaxial cell?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Show the p-v and t-s diagrams for the process

Water in a piston/cylinder at 400?C, 2000 kPa is expanded in a reversible adiabatic process. The specific work is measured to be 415.72 kJ /kg out. Find the final P and T and show the P-v and T-s diagrams for the process.

  Determine the mass fractions of the constituents of air

The composition of moist air is given on a molar basis to be 78 percent N2, 20 percent O2, and 2 percent water vapor.

  Calculate the magnitude and direction of horizontal force

calculate the magnitude and direction of the horizontal force exerted on the contraction (not on the water). Assume that there is no loss of energy in the contraction. Use the gamma of water is equal to 1000 kg/m^3

  Do any of the three wells exceed the 44 ppm level

Nitrate concentrations are often recorded in units of NO3--N/L to be compared with other nitrogen constituents. Near three rural wells nitrate concentrations were reported as 0.25 mg

  Determine the factor of safety against overturning

The factor of safety is defined as the ratio of the stabilizing moment divided by the overturning moment. The densities of concrete and water are = 2.40 and = 1 , respectively. Assume that the dam does not slide.

  Calculate the head loss with a roughness height

A galvanized iron pipe with a roughness height (e) of 5x10-6 m with a diameter (D) of 0.05 m and a length (L) of 100 m carries a discharge (Q) of 0.003 m3/s. Calculate the head loss (hL).

  Determine what is the concentration in lake water with ph

What is the concentration (M) of Al3+ in lake water with pH = 4 assuming the equilibrium below with excess Al(OH)3 (s) The reaction is Al(OH)3 (s) --> Al3+ + 3OH-. pKsp = 32.9.

  Is there any relation among dz, (?z)x, and (?z)y

Consider the function z(x, y), its partial derivatives (∂z/∂x)y and (∂z/∂y)x, and the total derivative dz/dx. (a) How do the magnitudes (∂x)y and dx compare?

  Determine angular acceleration and velocity of the link

Peg P is driven by the fork link OA along the curved path described by r = (2*theta) ft. At the instant theta = pi / 4, the angular velocity and angular acceleration of the link are (theta-1dot) = 3.0 rad/sec and (theta-2dot) = 1.1 rad/sec^2

  Calculate neuron output for the following transfer function

calculate the neuron output for the following transfer functions

  A cantilever beam ab has a rectangular cross section

A cantilever beam AB has a rectangular cross section and is loaded by a force P at an angle α that acts at the centroid of the cross section. Two strain gages are placed at point C, which is at mid-height of the beam. Gage D measures the strai..

  What is the quality of the steam leaving the turbine

Steam enters the turbine of a single vapor power plant with a pressure of 10 MPa and a temperature of 580 C and expands adiabatically to 6 kPa. The isentropic turbine efficiency is 85%. Saturated liquid exits the condenser at 6 kPa and the isentropic..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd