Determine the size of the contact patch and contact stresses

Assignment Help Mechanical Engineering

Reference no: EM13709595

Determine the size of the contact patch, the contact stresses, and the maximum shear stress for a 40 mm diameter steel cylinder, 25 cm long, rolled against a flat plate with a 4 kN force pressing the cylinder onto the flat plate.

Reference no: EM13709595

Questions Cloud

Find the initial pressure and mass of the system : Water in the pictured piston cylinder assembly has an initial quality of 10%. The piston cylinder is 20 cm in width and the piston is initially 40 cm high. Heat is added until the temperature of the steam reaches 500°C. While heat is being added the ..

Steam flows steadily through an adiabatic turbine : Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 10MPa, 450C and 83 m/s, and the exit conditions are 10kPa, 92 percent and 42 m/s. The mass flow rate of the steam is 12 kg/s.

The initial and final phase descriptions of the water : One-half kilogram of pure water is heated in a frictionless piston-cylinder device, at a constant pressure of 200 kPa, from an initial temperature of 20oC to a final temperature of 400oC.

Kinetic energy of the air within the chamber is negligible : An air cushion vehicle is supported by forcing air into the chamber created by a skirt around the periphery of the vehicle as shown in Fig. P3.106. The air escapes through the 1.7-in. clearance between the lower end of the skirt and the ground (or wa..

Determine the size of the contact patch and contact stresses : Determine the size of the contact patch, the contact stresses, and the maximum shear stress for a 40 mm diameter steel cylinder, 25 cm long, rolled against a flat plate with a 4 kN force pressing the cylinder onto the flat plate.

Masses connected together with a mass less rigid-link : Given three masses connected together with a mass less rigid-link, where should you place the single mass if you want to replace these masses with it?

Steam enters diffuser operating steady state with pressure : Steam enters a diffuser operating at steady state with a pressure of 14.7 psi, a temperature of 300F, and a velocity of 500ft/s. Steam exits the diffuser as a saturated vapor with negligible kinetic energy. Heat transfer occurs from the steam to its ..

Determine the exit velocity of the nitrogen : Nitrogen gas at 65kPa and 7C enters an adiabatic diffuser steadily with a velocity of 210 m/s and leaves at 119kPa and 22C. Determine the exit velocity of the nitrogen. the ratio of the inlet to exit area

What must be the surface area of the lift cylinder : A hydraulic lift must lift 7000 lbs using oil that is under pressure of 130 lbs/in^2. what must be the surface area of the lift cylinder?

User Account

All Pages