Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A water treatment plant is processing water at s flow rate of 0.26m^3/s. The hydraulic detention times for the rapid mix tank, flocculation basin and the rectangular sedimentation basin are 10 sec, 30 min, 60 min, respectively. The velocity gradients for the rapid mix and the flocculation tanks are 1000s^-1 and 60:40:20s^-1, respectively. The dynamic viscosity of water is 0.001 Pa-s and the motor efficiency is 80%. Use two parallel treatment trains.
a)- Determine the size and power requirements for rapid mixb)- Determine the size and power requirements for flocculation basin stagesc)- Determine the size of sedimentation basin and the overflow rate for a water depth of 4 md)- What is the percent removal of two particles with settling velocity of 0.001 and 0.002 m/s in the sedimentation basin is the basin is (i) a rectangular tank and (ii) an up flow clarifier?
A lagoon with volume 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply
Using darcy-weisbach equation, calculate the major friction head loss for a 24 inch diameter, 120 ft long pipe that can carry water with a flow rate of 5 cfs. Assume the temperature of water is 70 deg F and the roughness of the pipe is 0.0016 ft.
In bridge widening projects, the method of stitching is normally employed for connecting existing deck to the new deck. What are the problems associated with this method in terms of shrinkage of concrete
The velocity out of the tube may be approximated by V = √(2(p-patm)/ρ), where p is the absolute tank pressure. Determine the time at which the pressure (gage) in the tank is 20 kPa if the initial pressure is 40 kPa (gage)
The slabs are to be built integrally with the end supports, which are spandrel beams. fy = 60,000 psi, fc' = 4000psi normal-weight concrete. Clear spans are 15 feet, 18 feet and 15 feet. with the longitudal span of 38 feet.
What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface
Estimate the critical pressure of a mixture of methane and n-hexane if the critical temperature of the mixture is known to be 200 F. Compare your answer with the critical pressures of pure methane and pure n-hexane.
Determine: a) the height of the water, with respect to the base of each standpipe, and b) the effective stress at the depth of each standpipe, at the following times:
Two links AB and B, each 25 in. long are connected at B and guided by hydraulic cylinders attached at A and D. Knowing that D is stationary and that the velocity of A is 30 in./s to the ight
A soil is to be compacted on a site and it is expected that the soil contains a high percentage of montmorillonite. Briefly explain the working principles of two tests that can be carried out to ascertain the presence of montmorillonite in the soil.
The flywheel of a prototype car engine is under test. The angular position of the flywheel is given by x = (3.0rad/s3)t3 and the diameter of the flywheel is 36cm.
A 400ft equal-tangent sag vertical curve has its PVC at station 200 + 00 and elevation 250ft. The initial grade is -5.0% and the final grade is +2.5%. Determine the elevation of the lowest point of the curve.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd