Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Consider a CS amplifier with a resistance Rs in the source lead and with the drain short-circuited to ground. Determine the short-circuit transconductance G m. Hence provide the output equivalent circuit of the source-degenerated CS amplifier, and show that the open-circuit voltage gain Avo =: -Ao·
If voltage and resistance are measured as a means of indirectly measuring power, show again that if the relative uncertainties in the direct measurements are +2%, that the relative uncertainty in the indirectly measured power will be +6%.
Is the second law satisfied? Will this refrigerator still satisfy the second law if its coefficient of performance is 6?
When a forward bias is applied across a junction is the increased current flow due to movement of the Fermi level closer to the band edge or to lowering of the potential barrier. If you want to increase the space charge width on the n side of a p,n..
Determine the phase angle difference between the voltage and current, and whether the voltage leads or lags the current, if (a) V = 240/243 V rms and I = 3/9 A rms; (b) the power factor of the load is 0.55 lagging; (c) the power factor of the load..
Write a 68000 assembly program to subtract two strings of A15 ASCII characters. The first string is stored starting at $502030. The second string is stored at location $302510. The ASCII character in location $502030 of string.
A three phase bridge rectifier has a purely resistive load of R= 100 ohm and is supplied from a 280 V, 60 Hz supply. The primary and the secondary of the input transformer are connected in Y. Determine the average output voltage of the rectifier
Signal Definitions are A.H, B.L ,C.L, D.H and Z.L. It is recommended you apply DeMorgan's Theorem first to the above equation. Draw (on paper) a circuit diagram implementing Z, using the minimum number of gates.
An LED is rated at VF = 1.6 Volts to 2.0 Volts at IF = 20 mA. What value of series resistance is needed to limit the LED current to 20 mA when this LED is connected to a 32 Volts peak source
The sampling frequency in a DSP system is fs=8 kHz. Anti-aliasing filter used in the system is the second-order Butterworth filter with cutoff frequency of fc=3.4 kHz. What is the percentage of aliasing level at the frequency f=2.5 kHz
The capacitor has to have the following specifications: Needs to provide 100 horsepower for 10 hours Max operation voltage of 480V The min and max for the dielectric and metals are: 10 nm
What are the major classes of UML diagrams or drawings. Five a one or two sentence description of the purpose of each type of drawing. What are the major elements that should be included in a dynamic model.
The average power is not necessarily equal to the average current times the average voltage. To show this, find a voltage waveform and current waveform where each has a zero average value but their product has a non-zero value.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd