Determine the shear force and bending moment diagrams

Reference no: EM13542300

1.Why do the X components of the reaction forces need to be considered when resolving the moment about point A?

2.A wood mallet has a cylindrical head 6 inches long and 3 inches in diameter. If the cylindrical head is 1 inch in diameter how long must it be for the mallet to balance at a point 6 inches from where the handle enters the mallet? (use 40 lb / ft cubed) for wieght of wood.

3.A tube is placed in a certain liquid and its capillary rise is 1.5cm. What would be the rise of the same tube were placed in another liquid that was half the ? and half its ?. Assume T = 0°.

4.A 200 lb divers stands on the end of the diving board. determine the shear force and bending moment diagrams

Reference no: EM13542300

Questions Cloud

Apply corrections for temperature pull and sag to determine : What is the water content and liquidity index of the fines in compacted mass?A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long.

Calculate the linear density of atoms in these directions : For FCC diamond cubic structures, give the lattice coordinates for the atoms found in the [100], [110], [111] direction? and Calculate the linear density of atoms in these directions for Ge.

Determine the correct horizontal distance considering : A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long. The difference in elevation between the initial and the end point was found to be 1.25 m

Draw the influence line for the shear at point b : Draw the influence line for the shear at point B. Plot numerical values every 5 ft. Assume the support at A is a roller and C is fixed. EI is constant.

Determine the shear force and bending moment diagrams : A wood mallet has a cylindrical head 6 inches long and 3 inches in diameter. If the cylindrical head is 1 inch in diameter how long must it be for the mallet to balance at a point 6 inches from where the handle enters the mallet? (use 40 lb / ft cube..

What rate of perspiration would be needed to maintain a : Considere a person who consumes 2100 kcal par day, of which 2000 kcal is converted thermal energy.( the remaining 100 kcal is used to do work on the environment.) The person has a surface area of 1.8 m² and is dressed in a bathing suit.

Should the company proceed with the process change : The company Eco-Safe is adding pollution control equipment to its process and reducing emission of pollutants. The annual waste disposal cost of the current process is $130,000 and the annual operating cost is $600,000

Determine the viscosity of the fluid : Two parallel plates are separate at a distance of 2mm by a fluid. If a shearing stress of 150 Pa is developed at the upper plate when it is pulled at a velocity of 1m/s. Determine the viscosity of the fluid.

The sydney transportation company operates : The sydney transportation company operates an urban bus systemin new south wales australia. economicanalysis performed by the firm indicates that two major factors influence the demand for its services

User Account

All Pages