Determine the shaft and size fittings

Assignment Help Mechanical Engineering

Reference no: EM131240269

Question 1:

Figure Q1-A shows a welded steel bracket loaded by a static force, F, of 8 kN. Estimate the factor of safety if the allowable shear stress in the weld throat is 105MPa.

Figure Q 1-A

1-B

Figure Q 1-B illustrates a typical lap joint design using adhesive bonding. What is the major problem that is inherited in such design? Propose and show graphically FOUR (4) designs which are able to reduce the problem stated above.

Figure Q 1 -B

Question 2:

2-A

Figure Q2-A shows two gears A and C attached to a shaft supported by bearing and B and D. Forces acted on gear A and C are 180 N and 200 N respectively. Draw load, shear force, bending moment and shaft torsional moment diagrams for the shaft, in both XY and XZ planes, and then locate the most endangered x-section of the shaft. You need to determine the shaft and size fittings and then the drawing of the shaft.

Figure Q 2-A

2-B

The figure shown (figure Q 2-B) is geared countershaft with an overhanging point at C. Select an angular contact ball bearing for mounting at O and a straight roller bearing for mounting at B. the force on gear A is FA = 2670N, and the shaft is to run at a speed of 450 rpm. Specify the bearing required, using an application factor of 1.4, a desired life of 50 000 h, and a combined reliability goal of 0.9.

All dimensions are in mm

Reference no: EM131240269

Questions Cloud

Determine the minimum allowable diameter of the conduit : A hydroelectric turbine passes 2 million gal/min through its blades. If the average velocity of the flow in the circular cross-section conduit leading to the turbine is not to exceed30 ft/s, determine the minimum allowable diameter of the conduit.

Deadlock using updates on person : Cause a deadlock using updates on Person. Person and Human Resources. Employee. You will have to run different queries in sequence within two transactions using at least two query windows within Management Studio to do this.

Estimate the credit default swap spread : Suppose that the recovery rate is 30% and the default probabilities each year conditional on no earlier default is 3%. Estimate the credit default swap spread. Assume payments are made annually.

Explain the mac process : Briefly explain the MAC process and all of the frames that are used during this process. Please include a 100-200 word conclusion, outlining your results. Your study should include a "Works Cited" page and contain internal cites, giving credit t..

Determine the shaft and size fittings : Estimate the factor of safety if the allowable shear stress in the weld throat is 105MPa - What is the major problem that is inherited in such design? Propose and show graphically FOUR (4) designs which are able to reduce the problem stated above -..

Determine the magnitude and direction of the shearing stress : A layer of water flows down an inclined fixed surface with the velocity profile shown in Fig. P12.2. Determine the magnitude and direction of the shearing stress that the water exerts on the fixed surface for U = 3 m/s and h = 1 m.

Which sources were easiest to use and most beneficial : Which sources were easiest to use and most beneficial? Did they give salary ranges for the career you chose? Did they include educational requirements?

Explain the two ways a credit default swap can be settled : Explain the two ways a credit default swap can be settled. - Explain how a cash CDO and a synthetic CDO are created.

Regular credit default swap and a binary credit default swap : Explain the difference between a regular credit default swap and a binary credit default swap. - List the cash flows and their timing for the seller of the credit default swap.

User Account

All Pages