Determine the secondary sludge produced per day per pound

Reference no: EM13561470

A low rate trickling filter plant gives 95% BOD5 removal. the primary clarifier removes 33% of the BOD5 applied to it. the secondary sludge amounts to 0.029lb dry solid/cap-day. if the raw wastewater has a BOD5 of 0.17lb/cap-day. determine the secondary sludge produced per day per pound of BOD5 removal.

Reference no: EM13561470

Questions Cloud

How long would it take for the clay layer to achieve : A 3m deep layer of clay is underlain by impervious rock. An extensive area of fill is to be placed over the site.

How long would it take for 80% consolidation of the clay : A 4m deep clay layer is underlain by impermeable shale. A sample of clay from the layer is subjected to an appropriate increment of stress in a consolidation test giving the following results:

Discuss the signals and systems as they exist in these : A square footing 0.3 m by 0.3 m is placed on the surface of a dense cohesionless sand (unit weight = 18.2 KN/m^3) and subjected to a load test. If the footing fails at a load of 13.8 KN, what is the value of ? (degree) for the sand?

Calculate the screen drag force : A variable mesh screen produces a linear and axisymmetric velocity profile as indicated below in the air flow through a 2-ft diameter circular cross section duct.

Determine the secondary sludge produced per day per pound : A low rate trickling filter plant gives 95% BOD5 removal. the primary clarifier removes 33% of the BOD5 applied to it. the secondary sludge amounts to 0.029lb dry solid/cap-day. if the raw wastewater has a BOD5 of 0.17lb/cap-day.

Determine the volume of stone required for each filter : A two stage high rate trickling plant is to treat a municipal wastewater having a flow of 2.0mgd. pertinent data: influent BOD5 = 200mg/l, BOD5 removal by primary clarifier = 33%, filter bed depth = 5 to 7ft,

How long until the concentration is reduced : The Fluoride feeder runs out of feed solution. The rapid mix tank is connected to a 5 km long distribution pipe. The flow rate into the tank mix tank is 0.44 m?/s and the volume of the tank is 2.50 m?.

Determine the force supported by the hydraulic cylinder : A Steel plate weighing 205 lb with a center of gravity at point G is supported by a roller at point A,a bar DE, and a horizizontal hydraulic cylinder BC. Negelcting all weights of all members except for the plate,

What is the maximum acceleration from rest of the car : A car has a 10-ft wheelbase (L). the center of gravity is 18 inches about the ground and 5 ft behind the front axle. The weight of the car is 2500 lb. mechanical efficiency if the drivetrain is 85%. and the wheel radius is 15 inches

User Account

All Pages