Determine the s-n improvement due to the pre-emphasis

Assignment Help Electrical Engineering
Reference no: EM13275889

An FM receiver is modulated with a signal having a baseband bandwidth of 15 kHz and the maximum frequency deviation is 45 kHz. Assume that preemphasis is added with a 3-dB boost frequency of 5 kHz. Referring to the information above, determine the S/N improvement (in dB) due to the pre-emphasis.

Reference no: EM13275889

Questions Cloud

What is the highest point he reaches above the water : A diver springs upward with an initial speed of 2.19 m/s from a 3.0-m board. What is the highest point he reaches above the water
Explain how many atoms of chromium are used in the coating : An object is coated with a layer of chromium that is 0.015 cm thick. If the object has a surface area of 15.3 cm squared, how many atoms of chromium are used in the coating. The density of chromium is 7.19 g/cm cubed.
Estimate the speed of the ball : A soccer player kicks the ball toward a goal that is 21.0 m in front of him. Find the speed of the ball when the goalie catches it in front of the net
State degree of unsaturation or index of hydrogen deficiency : The degree of unsaturation, or index of hydrogen deficiency, is the number of pi bonds plus rings in a molecule. Specify the degree of unsaturation (index of hydrogen deficiency) of the following formulas
Determine the s-n improvement due to the pre-emphasis : An FM receiver is modulated with a signal having a baseband bandwidth of 15 kHz and the maximum frequency deviation is 45 kHz. Assume that preemphasis is added with a 3-dB boost frequency of 5 kHz.
Find the total linear acceleration of a point : A racecar accelerates uniformly while starting from rest, find the total linear acceleration of a point on the outside of the tire when the car has traveled a distance of 200 m
Determine the approximate detected s-n ratio : The bit energy to one-sided noise density at a PCM receiver input is 30 dB. Referring to the figure above, determine the approximate detected S/N ratio (in dB) for 8-bit BPSK with a matched filter detector.
State net ionic equation for a solution of calcium chloride : write the net ionic equation for a solution of calcium chloride and a solution of mercury(1) nitrate
Will temperature of air rise as compressed by compressor : Consider an air compressor operating steadily. How would you compare the volumetric flow rates of the air at the compressor inlet and outlet. Will the temperature of air rise as it is compressed by an adiabatic compressor.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Implement a circuit that generates vga signals

implement a circuit that generates VGA signals to draw a blue screen on your monitor in a resolution of 640x480. The following materials provide detailed descriptions of how VGA signals operate and some hints on how to design the VGA controller

  Find what is the molarity of the resulting solution

1- Use the half-reaction method to balance the equation Ca(s) +Cl2(g) --> CaCl2(s). 2-A sample of sodium chloride, NaCl, weighing 0.0678 g is placed in a 25.0-mL volumetric flask. Enough water is added to dissolve the NaCl, and then the flask is ..

  What is the value of the density of electrons

If the semiconductor depicted in the graph below is germanium at room temperature, what is the value of n (the density of electrons in the conduction band) at x=L

  How many quantization bits must be used to satisfy

An analog signal ranging between 0 and 1 V must be quantized. The midrange quantization errors must be no greater than 0.1V. How many quantization bits must be used to satisfy this requirement

  Calculate the psi tensile stress on the loaded wire

A 1 lb weight is suspended from a 0.005 in diameter wire. The unstrained resistance of the wire, R0, is 270 ohm, and its unstrained length is L0=36 in. The wire's gauge factor is 3.2. a. Calculate the psi tensile stress on the loaded wire.

  What is the mechanical rotational velocity

An AC synchronous motor operates at 1200 rpm on a 60 hz, 240 Vrms supply. The supply is changed to 50 hz, 240 Vrms, What is the mechanical rotational velocity when the motor reaches steady state

  What is the rms value of the largest sin-wave input

An amplifier with 40 dB of small-signal open-circuit voltagegain, an input resistance of 1M-ohm ,and an output resistance10-ohm drives a load of 100-ohm .What voltage and power gains(expressed in dB) would you expect with the load connected

  Find the input impedance into this line at z

A transmission line with no loss, with Z0= 60 ohms, is operated at 60MHz. The velocity on the line is c. The line is soldered to a ground connection at z=0. Find the input impedance into this line at z= -1.25 meters

  Find the frequency response of the system

For the system represented by the following difference equation y[n] = 0.5x[n] + 0.5x[n - 1] find: (a) the transfer function H(z) of the system. (b) the frequency response H(e^jw) of the system.

  Write programme to copy values from array1 to array2

Write a HCS12 assembly-language program that copies values from ARRAY1 to ARRAY2 until it copies 10 values, or a value in ARRAY1 that is equal to zero.

  Calculate the new depth of water in the conical tank

a closed conical tank with diameter of 1.50 and height of 3.00 m, sitting on its circular base has 1.00m depth of water. Suppose the tank is upside down and is made to stand vertically that way using some device.

  At most how many 1-operand instructions can be formulated

A computer has 16-bit instructions and 64 registers. Suppose it is required to have at least 14 instructions designed to have 2 operands from registers (e.g., add, $1, $3 puts the sum of $1 and $3 into $1.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd