Determine the resultant lift force p that this wing

Assignment Help Mechanical Engineering

Reference no: EM13628524

The wing is supported by a strut BE with ball-and-socket joints at B and E, and by bearings at A and F. The bearings are perfectly aligned and are supported by a straight shaft which is fixed to the fuselage, and bearing A is a thrust bearing. Bearings A and F lie on the x-axis, point B lies on the y-axis, point E lies on the z-axis, and points Ca nd D lie in the xy plane. The plane's mass, including fuel, passengers, and cargo is 1000kg, and it flies so that it is in static equilibrium. The strut BE has negligible mass and the wing ABCDF has a 200kg mass with center of gravity at point B. The force Q acts in the -x direction and is due to air drag.

(a) Determine the resultant lift force P that this wing supports, assuming this force is vertical and that only the wings provide lift.

(b) If the drag force Q is 10% of the lift force P, determine the force supported by the strut BE and the reaction at bearings A and F.

Reference no: EM13628524

Questions Cloud

Drmine a the temperature of the air at the compressor : the turbocharger of an internal combustion engine consists of a turbine and a compressor. hot exhaust gases flow

A uniform electric field aibj intersects a surface of area : a uniform electric field aibj intersects a surface of area a. what is the flux through this area if the surface lies

Compression is isentropic to the condenser pressure of : the following figure shows the schematic diagram of a vapor compression refrigeration system using r-134a as the

A 350 cm diameter loop is rotated in a uniform electric : a 35.0 cm diameter loop is rotated in a uniform electric field until the position of maximum electric flux is found.

Determine the resultant lift force p that this wing : the wing is supported by a strut be with ball-and-socket joints at b and e and by bearings at a and f. the bearings

Consider a regenerative vapor power cycle with two : consider a regenerative vapor power cycle with two feedwater heaters a closed one and an open one. steam enters the

Write all the necessary boundary conditions to determine : consider a solid cylinder of radius r and height h. heat is generated in the solid at a uniform rate of q wm3. one of

To the dismay of scientists on earth an electrical fault : an unmanned spacecraft is in a circular orbit around the moon observing the lunar surface from an altitude of 49.0km .

As the airplane begins its takeoff run at t 0 the normal : as the airplane begins its takeoff run at t 0. the normal forces exerted on its tires at a and b are na 4.2 kn and nb

User Account

All Pages