Determine the response of the measurement system

Assignment Help Mechanical Engineering

Reference no: EM13701668

A measurement system can be modelled by the equation given below, (5/8)y' +y=F(t).

The output signal is initially steady at 5 V. The input signal is then suddenly increased to 8 V.

i) Determine the response of the measurement system. [2 pts]

ii) Plot both input signal and the system response from t = 0 s through the steady response

Reference no: EM13701668

Questions Cloud

Vertical at the opposite tip of the first triangle : Determine the force in each member below by using the methods of joints. one force is 4kN at 30 degrees at the tip of the first triangle, and another 3kN force is vertical at the opposite tip of the first triangle.. There are 8 members composed of 4 ..

Hydrostatics and stability-lightship condition : Hydrostatics and stability-In lightship condition, how does the ship trim and why? How does the ship react when weights are added or subtracted? How does the curve of statical stability change with vertical shift of weights?

Determine the systems thermal efficiency : Air enters a three-stage gas turbine at 100 kPa and 17 degree Celsius. This system uses a regenerator as well as reheating and inters cooling. The pressure ratio across each compressor is 14.16 (this is 14.16, NOT 14 and 16!); 300 kJ/kg of heat are a..

Domestic hot water supply : Steam at 500 kPa, 300 degrees C is used to heat cold water at 15 degrees C to 75 C for a domestic hot water supply. How much steam per kilogram of liquid water is needed if the steam should not condense?

Determine the response of the measurement system : A measurement system can be modelled by the equation given below, (5/8)y' +y=F(t). The output signal is initially steady at 5 V. The input signal is then suddenly increased to 8 V. Determine the response of the measurement system.

The two purposes of amplification for digital systems : The two purposes of amplification for digital systems are (i) to improve signal-to-noise ratio and (ii) to make good use of the dynamic range of the digitizer; in other words, to ensure the best resolution possible.

What is the gain required to make the digital resolution : The voltage output from a 0–50 psi pressure transducer will vary from 0–5 mV. The input/output relationship is linear. The signal will be recorded with a 12-bit A/D converter with a 0-10 V input range. The voltage output needs to be amplified before ..

Calculate drag force on flat bottom boat : Calculate drag force on flat bottom boat. What power is required to keep the boat moving at 0.5 m/s?

Find the power output in mw and the thermal efficiency : Consider a 2500 psia/1000 F turbine inlet, single reheat to 1000 F cycle with a reheat pressure ratio of P2/P1= 0.2 and a steam mass flow rate of 2 x 10^6 ibm/hr. The condensor operates at a pressure of 1 psia. Pump and turbine isentropic efficiencie..

User Account

All Pages