Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Water is contained in a pressurized tank to a level of z meters above the ground. the air pressure over the water surface (in the tank) is 135kPa (abs). Assume the water density is 1000 kg/m^3 and take g=9.807 m/s^2. If the water pressure at ground level is 60 psia, determine the required height, z in meters. Provide all work to receive good rating.
A U manometer reads 20 cm air as operating fluid and a given manometric fluid. A single branch closed tube reads 35 cm connected to point 1. If P2 = 1.2 ATM calculate the pressure in point 1 and the density of the manometric fluid.
could you please help me to figure out what the meaning of steady state in the pavement management system preservation and rehabilitation.
What are the quantitative measures of reliability (discuss measures for hardware, software, personnel, facilities, and data)?
The maintenance costs begin in 31st year at $300,000 annually. How much must be deposited now if the fund will earn 5% interest. How much does this change if the interest rate is 4%
Determine the magnitudes of the additional loads that must be applied at B and F if the resultant of all six loads is to pass through the center of the mat.
What is the maximum column load in kips that could be placed on a 4-ft square temporary footing on a sand for which the standard resistance is about N=15 and the water table is at the surface? A factor of safety of 2 is to be maintained against be..
A hydroelectric facility operates with an elevation difference of 50.0 m with a flow rate of 500 m3/sec. If the rotational speed is 90 rpm, determine the most suitable type of turbine and estimate the power output of the arrangement.
Energy transfer in mechanical systems, A wheel is 800mm in diamiter and has a mass of 1000kg. on a horizontal surface without skidding, the vehicle accelerates uniformly at 0.5m/s^2 for 5 seconds.
Water flows in a 100-m long pipe at 3 m/s. If the water temperature is 20 degrees C, determine the minimum valve-closure time to avoid creating the water-hammer pressures. What is the maximum water-hammer pressure that can occur
The pH of tap water might be adjusted to the 8 to 9 range to reduce the potential for corrosion of metal pipes in the water distribution system.
A four lane freeway (two lanes in each direction) operates at capacity during the peak hour. It has 11-ft lanes, 4-ft shoulders, and there are three ramps within three miles upstream of the segment midpoint and four ramps within three miles downst..
Given that the seperation distance between the charges is 5m, q1 = -3q2, find the position where the net electric field is zero. Do not use infinity.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd