Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
The compression stages in the axial compressor of the industrial gas turbine are close coupled, making intercooling very impractical. To cool the air in such compressors and to reduce the compression power, it is proposed to spray water mist with drop size on the order of 5 microns into the air stream as it is compressed and to cool the air continuously as the water evaporates. Although the collision of water droplets with turbine blades is a concern, experience with steam turbines indicates that they can cope with water droplet concentrations of up to 14 percent. Assuming air is compressed isentropically at a rate of 2 kg/s from 300 K and 100 kPa to 1200 kPa and the water is injected at a temperature of 293 K at a rate of 0.2 kg/s, determine the reduction in the exit temperature of the compressed air and the compressor power saved. Assume water vaporizes completely before leaving the compressor, and assume an average mass flow rate of 2.1 kg/s throughout the compressor.
a shaft is subjected to bending and torsion such that the bending stress on the surface is 80 mpa and the shear stress
draw a block-diagram of a yaw rate damping system.include the following components the airframe the rudder actuator the
Sketch the frequency response of the system. Overlay the frequency spectrum of the excitation and as you start the system up, increasing Ω from 0 to 60 rpm, what speeds are most likely to excite large amplitude response? Why?
design 2-shell pass and 8-tube pass heat exchanger for heating ethyl alcohol from 25degc to 70degc at a rate of 2.9
use the principle of angular momentum to eventually derive the moment of inertia integral. for each case find the
a cartridge electrical heater is shaped as a cylinder of length l 200 mm and outer diameter d 20 mm. under normal
a tank contains a gas at an absolute pressure of 104.0 kpa. the pressure in the tank is measured using a mercury p13.59
a cylindrical metal specimen having an original diameter of 11.05 mm and gauge length of 51.7 mm is pulled in tension
a cylinder of metal that is originally 100mm tall and 50mm in diameter must be open die forged to a height if 50mm. the
q1 write a matlab code which must have following inputs and outputsinputs1. an arbitrary geometry matrix2. basis
Describe IN DETAIL how you could determine the required rate of heat addition or removal.
one end of a copper rod 30 cm long is held at 200degc and the other end is held at 93degc. the heat transfer
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd