Determine the reaction rate constant to be first order

Assignment Help Civil Engineering
Reference no: EM13316879

A reaction in a batch system is assumed to be first order. Data listed below was collected. Determine the reaction rate constant.

chemical concentration (ug/L) time(min)
19.3 6
26.0 9
32.6 12
36.0 14
41.3 18
45.0 22
46.5 24
47.4 26
50.4 30
58.3 infinite

Reference no: EM13316879

Questions Cloud

What minimum applied force is needed to open the gate : A rectangular gate is inclined at an angle of 30 degrees from the horizontal. It is 4 ft wide by 6 feet long. If it is hung from its upper end which is 8 feet below the waters top edge, what minimum applied force (bottom) is needed to open the gat..
How much louder does the traffic noise seem : When the decibel of traffic in the street goes from 40 to 60 dB, How much louder does the traffic noise seem
What is the range of values of a for which the body moves : The motion is described by the second Newton's law: m(d^2y/dt^2) + a(dy/dt) + ky = 0 where y is the body displacement in m, t is the time in s, a > 0 is the friction coeffcient in kg/s and k is the spring constant in kg/s2.
Calculate the water pressure on the second floor : The water pressure in the pipes in the basement of a tall house is 5.1 105 Pa. Calculate the water pressure on the second floor
Determine the reaction rate constant to be first order : A reaction in a batch system is assumed to be first order. Data listed below was collected. Determine the reaction rate constant. chemical concentration (ug/L) time(min) 19.3 6
Find the change in mechanical energy of the elevator : 2000 kg elevator is accelerated uniformly from rest to 4 m/s in a time of 90s. find the change in mechanical energy of the elevator
What category information is collected by the site : Information has many facets: value, confidentiality, integrity, privacy, legality, and so on. All information is not the same and hence its protection requirements may vary.
How long will it take for concentration to be one-quarter : A batch system is assumed to be first order. The initial concentration is 225 mg/L. If the reaction rate constant is 0.65 hr^-1, how long will it take for the concentration to be one-quarter the starting concentration
What is the electric potential energy of the center electron : Three electrons are aligned on a straight line and separations between them are 1.0mm. What is the electric potential energy of the center electron

Reviews

Write a Review

Civil Engineering Questions & Answers

  Write program that asks for diameter of two different sphere

Write a program that asks for the diameter of two different spheres. Then display to the user, the Maximum, Minimum, and Average volume of the spheres. Display this result in different lines of ONE message box by using VBCRLF.

  What will be degree of saturation of the compacted embanment

An earth embankment is compacted at water contect of 17% to a bulk density of 1.90 gm/cc.If the specific gravity of soil grains is 2.65, then what will be the degree of saturation of the compacted embankment

  Determine what percent of the hocl is dissociated

A solution of HOCl is prepared in water by adding 15 mg HOCl to a volumetric flask, and adding water to the 1.0 L mark. The final pH is measured to be 7.0. What are the concentrations of HOCl and OCl

  Dimensions of symmetrical trapezoid plate

The plate is submerged in a liquid is a vertical position with the parallel sides horizontal and the shorter parallel side at the top and exactly in the surface of the liquid.

  Compare the total reactor volume required for removal

Compare the total reactor volume required for 90% removal of a substance that decays according to first-order kinetics with a rate constant of 0.05 day -1 in a CM system that contains a single reactor against a system that contains three CM reacto..

  What is the velocity head expressed in atmospheres

What is the velocity head expressed in atmospheres for a rapid filter operated at a surface loading rate of 475 m/d when the local porosity is 0.40?

  Explain which illuminates a light indicating bowls contents

A scale for rapidly weighing ingredients in a commercial bakery operation is shown. An empty bowl is first placed on the scale. Electrical contact is made at point A, which illuminates a light indicating the bowl's contents are underweight.

  Determine the mass flow raw through the nozzle

Air enters an adiabatic nozzle steadily at 300 kPa, 200?C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm2. Determine (a) the mass flow raw through the nozzle, (b) the exit temperature of the air, and (c) the e..

  Determine speed at which student conducted her experiment

A student is trying to test the braking ability of her car determined that she needed 18.5 ft more to stop her car when driving downhill on a road segment of 5% grade than when driving downhill at the same speed along another segment of 3% grade.

  What is the maximum amount of cargo that can be carried

A small truck is to be driven down a 4% grade at 70mi/hr. The coefficient of road adhesion is 0.95, and it is known that the baking efficiency is 80% when the truck is empty and decreases by one percentage point for every 100 lb of cargo added.

  Structural health monitoring using guided wave propagation

Structural health monitoring using Guided Wave propagation for Detection and Evaluation of Flaws in Pipes.

  Probelm relating to fire a bullet

A bullet is fired from a height of 150m at a velocity of 300kmph at an angle of 35 upward. Neglecting air resistance. Find: a) total time of flight b) horizontal range

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd