Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Moist air at 450C and relative humidity 30% (State 1) with another stream of moist air at 20?C and relative humidity 50% (State 2) in an adiabatic duct. Mass flow rate of dry air is 0.8 kg/s at section 1 and 1 kg/s at section 2. The mixed stream (State 3) is cooled until condensation is about to begin (State 4) at the exit. Temperature of the cooling section boundary is maintained at 5?C. Total pressure is 1 atm throughout the system.
(a) Show the process for moist air on psychometric chart. Label states 1 through 4.
(b) Calculate temperatures (C) of the mixed stream at sections 3 and 4 and relative humidity (%) at section 3.
(c) Determine the rate of heat transfer (kW) in the cooling section.
(d) Find the rate of entropy generation (kW/K) in the cooling section.
a steel jacket e 200 gpa and v 0.3 having an inside diameter of 150 mm and an outside diameter of 200 mm is shrunk
a closed cylindrical tank that is 6 ft in diameter and 26 ft long is completely filled with gasoline. the tank with its
a tank contains 1 kg of carbon dioxide at 6 mpa 60 degrees celsius and it is connected to a turbine with an exhaust at
the boundary layer thickness g on a smooth flat plate in a incompressible flow without pressure gradient depends on the
Draw the front view and right view and the down-view.
the weather drops to 5 degrees celcius t1 so to keep warm you offer to make hot soup for the entire group. the
calculate the the maximum length on the small diameter of a shaft that is supported by a bearing at each end with a
0.89 pound-mass of water fills a 2.0309 ft^3 weighted piston-cylinder device at a temperature of 400 F. the piston-cylinder device is cooled until its temperature is 90 F. Determine the final pressure of the water and the volume.
the total cross-sectional area of the inlet to the jet engines is 20 ft2. assume that the flow properties of the air
an electric current of 0.25 a flows through a 5-ohm electrical resistor placed in an evacuated chamber. the resistor is
a bucket packed with 12 - inch diameter steel balls weighs 50 pound. when packed with 116-inch diameter steel balls the
Assume that the center of masses of the upper arm and the forearm acts in the geometric center of the respective body segment, and the center of mass of the hand acts at the same location that the cable is in the hand (given below). If the person is ..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd