Determine the rate at which heat must be transferred to the

Reference no: EM13545623

1.Saturated liquid water at 1.0 MPa is throttled adiabatically to a pressure of 0.4 MPa. If the change is kinetic energy is negligible, what percentage of the water evaporates during this throttling process?

2.A 50-ohm electrical resistor carries a current of 5 amperes. The resistor is maintained at a temperature of 30o C. Determine the rate at which heat must be transferred to the surroundings and the rate of entropy change of the resistor.

3.Wet steam at a pressure of 1382 kPa and a quality of 99% is throttled to a pressure of 689.5 kPA. Find the temperature after throttling.

Reference no: EM13545623

Questions Cloud

Calculate the respective thickness of the soild phase : An investigation of a particular site revealed a 4m thick deposit of peat overlying a deposit of soft clay .A 150 mm diameter by 300 mm long sample taken from the peat deposit was weighed and found to have a total mass of 5036 g and after oven-drying..

Compute the work done by the gas for constant pressure : Two pounds of an ideal gas are contained within a piston-cylinder arrangement. The initial volume and pressure are 1 ft3 and 75 psia respectively. The final volume is 3 ft3.

What is the estimated collection efficiency to improve its : Our ESP is collecting 95% of the particles in our exhaust stream. We are under pressure to improve its performance. It has been suggested that if we were to cool the inlet gas from the present 600°F to 250°F, the performance would improve

Calculate head supplied by the pump draw hgl and egl for : Water from a lower reservoir (water surface elevation) 500 m is pumping to the upper reservoir (water surface elevation 600 m) through a 5000 m long straight pipe with 0.5 m diameter.

Determine the rate at which heat must be transferred to the : Saturated liquid water at 1.0 MPa is throttled adiabatically to a pressure of 0.4 MPa. If the change is kinetic energy is negligible, what percentage of the water evaporates during this throttling process?

What is the local loss coefficient of the basket strainer : A basket strainer is installed in a 15-cm diameter pipe. Pressure gauges are installed immediately upstream and downstream of the basket strainer. When water flows at 100 m3/hr, the pressure gauge immediately upstream of the basket strainer measures ..

Determine the maximum water hammer pressure if the initial : A 1000 ft long steel pipe carries water from a reservoir with a water elevation at 826 ft. The pipe has a diameter of 12 in. with a wall thickness of .5 in. A gate valve at the downstream end is slowly closed during a half-mintue period

Calculate the total head loss for water flowing at 10 : Calculate the total head loss for water (25°C) flowing at 100 m3/hr as shown in the following figure. The total flow length is 250 meters and the pipe is 15-cm diameter cast iron pipe

What is the estimated collection efficiency at 250f : Our ESP is collecting 95% of the particles in our exhaust stream. We are under pressure to improve its performance. It has been suggested that if we were to cool the inlet gas fron the present 600F to 250F, the performance would improve.

User Account

All Pages