Determine the radius of the crank r

Assignment Help Mechanical Engineering

Reference no: EM13217082

Determine the radius of the crank R and the speed n of a slider crank mechanism, used in a shaker table. It is required that the average speed of the table is 5 m/s, and the maximum absolute acceleration is 3000m/s^2. Assume ratio R/L=0.2

Reference no: EM13217082

Questions Cloud

Derive the operational transfer function : Derive the operational transfer function and the sinusoidal transfer function for an RC high-pass filter. Plot the step response and the complete frequency response (magnitude and phase).

Present a risk assessment of a warehouse : These include risks associated with layout, floors, heating, noise, housekeeping and fire. Review these risks, and in a two page paper (not including the title and reference pages), present a risk assessment of a warehouse

Explain what constructs or concepts might you employ : What constructs or concepts might you employ? Choose several of the major concepts, and specify their dimensions.

Calculate the force of attraction : Calculate the force of attraction between a K+ cation and a O2- anion, the centers of which are separated by a distance of 1.5 nm.

Determine the radius of the crank r : Determine the radius of the crank R and the speed n of a slider crank mechanism, used in a shaker table. It is required that the average speed of the table is 5 m/s, and the maximum absolute acceleration is 3000m/s^2. Assume ratio R/L=0.2

Estimate the mass flow rate of fuel into the engine : Estimate the mass flow rate of fuel into the engine in kg/h.

Derive the linearised equation about the operation : For the pendulum shown in the figure,the restoring torque due to gravity is given by T=mgLsin(thita). Derive the linearised equation about the operation point thita=0.

Explain development of the design more effective : Explain and justify ideas that could have made the development of the design more effective. Support your recommendations with specific examples as appropriate.

Determine the number of bolts needed : A lap joint needs to be designed using 20-mm diameter bolts to carry a load of 120 kN on the connecting plates. If the shear stress in each rivet is not to exceed 90 MPa, determine the number of bolts needed.

User Account

All Pages