Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Determine the power transmitted through the shaft of a car when the torque applied is 200 N · m and the shaft rotates at a rate of 4000 revolutions perminute (rpm).
Zinc metal can be obtained from zinc oxide (ZnO), by reaction at high temperature with carbon monoxide (CO). ZnO(s) + CO(g) Zn(s) + CO2(g)The carbon monoxide is obtained from carbon.2C(s) + O2(g) 2CO(g)
Suppose we had connected at the input to channel 0 a circuit of the type that attenuates all frequencies above 50 Hz at a rate of 6 dB/octave. What will we then see in the output when we apply 4960 Hz at the input
A 10kVA, 200/400V 50Hz single-phase transformer gave the following test results. O/C test: 200V, 1.3A, 120W, on l.v. side. S/C test: 22V, 30A, 200W on h.v. side. (a) Calculate the magnetizing current and the component corresponding to core loss
The respective resistance measurements (from the first bar) are 11.1 kW, 12.1 kW, and 14.5 kW.Find the a) material resistivity and b) contact resistivity, then c) restate the material resistivity as a sheet resistivity.
trace how the electrons and holes move through the device under the two different biasing conditions. Explain how these three devices work in terms ofIn a study conducted at the National Institute of Mental Health,
A mote draws an average of 200mA when "awake", 0.1mA when "sleeping", and 400mA (total) when "transmitting". Transmitting data takes 2ms, and sensor acquisition takes 1ms. If the maximum size battery available is 5000mAh
if a 1mA movement has an internal resistance of 43 ohms, calculate the shunt resistance required to increase its range to 50mA and also 300mA.
a single phase 10kVA, 2400/120 V transformer has the following equivalent measurements (referenced to high side): Rc 64k ohms, Xm 9.6k ohms, Re 19.3 ohms, Xe 73.3 ohms. if the secondary load is Zl = 5 angle 30 degrees ohms
he sensor to be used has a transfer function of ? Q volts, where Q is in gal/min, and an output impedance of 2.0 k?. Tests show that the output of the sensor has 60 Hz noise of 0.8 V rms. Design a signal-conditioning system, including noise filter..
A nickel-iron ring withcross-sectional area 0.85cm2 is expected to be driven to itssatur-ation magnetization of 1.1T in a ?eld of 800 A/m. The ?ux density will be measured by an electronic ?ux integrator with input resistance of 1kOhm
What is the smallest frequency that can be used to sample each of the following continuous-time signals such that the signal can be recovered from the discrete samples (a) \(x(t)=1+cos(2000\pi t)+cos(4000\pi t)\)
A coaxial air line has an inner conductor diameter of 2mm and the inner diameter of the outer conductor is 4.6mm. A voltage of 1 V is applied to the inner conductor. Determine the surface charge densities on the inner conductor
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd