Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A Rankine cycle has a boiler pressure of 2500 psi and a condenser pressure of 1psi. The temperature at the inlet of the turbine is 800F. The turbine has an isentropic efficiency of 90 percent and the pump operates isentropically. The net work of the cycle is 1000kW of power. Determine: the mass flow rate, the power produced by the turbine, the rate of heat supplied to the boiler and the thermal efficiency.
A glass jar is heated in an oven and sealed when the air pressure is 103 kPa and the temperature is 105 C. Find the absolute, gage, and vacuum pressures in the jar when it cools to 20 C.
Conduct a Case Study on this disaster identifying safety management, safety audits, accident investigation, and industrial hygiene issues. Your Case Study should be a minimum of 500 - 600 words and contain the components listed above.
If direct runoff hydrgraph derived from a unit hydrograph of a catchment (drainage area = 50 acre) is 120 acre-ft, back calculate the rainfall amount. Assume total abstraction in the area is 50%.
Determine the liquid detention time, loading rate, F/M ration (with an MLSS of 2350 mg/l), sludge age (with 5330 lb/day waste sludge Eff. SS= 20 mg/l. Will the sludge settle properly
Briefly explain how each of the following influences the tensile or yield strength of a semicrystalline polymer and why: (a) Molecular weight (b) Degree of crystallinity (c) Deformation by drawing (d) Annealing of an undeformed material
A 500 L (132 gal) tank contains 255 mg/L 2,4,6-trichlorophenol dissolved in trichloroethylene (TCE). What is the 2,4,6-trichlorophenol concentration in ppm Assume the temperature of the system is 20 degrees C.
A 2 m high sandy fill material was placed loosely at a relative density of 47%. Laboratory studies indicated tht the maximum and minimum void ratios of the fill material are 0.92 and 0.53, respectively.
velocities in a 200-mm-diameter circular conduit, measured at radii of 0,36,64, and 87 mm were 7.0, 6.8, 6.1, and 5.0 m/s, respectively. Find the approximate values (graphically) of the volume flow rate and the mean velocity.
Determine the magnitudes of the additional loads that must be applied at B and F if the resultant of all six loads is to pass through the center of the mat.
In that season, what are the hydraulic radius of the river, its mean velocity and volumetric discharge?
It is known that a horizontal curve starts (has PC) 90m before the vertical curve's PVC. If the superelevation of the horizontal curve is .08 and the central angle is 38 degrees what is the station of the PT
Deflection of a Beam, If a beam of lenght L is fixed at the ends and loaded in the centre of the beam by a point load of F newtons the deflection
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd