Determine the power generated by the motor m

Assignment Help Mechanical Engineering
Reference no: EM13216513

The material hoist and the load have a total mass of 900 kg and the counterweight C has a mass of 150 kg. At a given instant, the hoist has an upward velocity of 4 m/s and an acceleration of 1.2 m/s^2. Determine the power generated by the motor M at this instant if it operates with an efficiency of epsilon = 0.8.

Reference no: EM13216513

Questions Cloud

Connection between moral character and political activism : What is the connection between moral character and political activism? Do you think there should be a link between good moral character and political activity?
Estimate the mass of the gas in the tank in kg : Estimate the mass of the gas in the tank in kg assuming the gas behaves as an ideal gas. If the gas warms up to 35 deg C as it sits in the sun all day, what would the pressure rise to?
Discuss what separates sociology from common sense : discuss what separates sociology from common sense? give examples of sociological research might dispel commonly accepted views
What are the angles : solution of oblique-angled triangle all threesides known two side at 7.5 in. and base at .3437 in. what are the angles ?
Determine the power generated by the motor m : Determine the power generated by the motor M at this instant if it operates with an efficiency of epsilon = 0.8.
Describe the kutta condition : Describe the kutta condition.
Determine the average applied force exerted on to the pile : determine the average applied force exerted on to the pile hammer. Note because the force is applied over a short time period it can be considered as an impulse force.
Determine the distance d between the cars : Determine the distance d between the cars at which the driver of car A must apply his brakes to just avoid colliding with carB.
Calcualte the efficiency of centrifugal compressor : I would expect somthing like the requirement to execute the equation, please explain each term in the equation with its engineering units.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Calculate the mass of neon gas in si units

A volume of 1.8 L of neon gas (monatomic) is at a pressure of 3.4 atmospheres and a temperature of 370 K. The atomic mass of neon is 20.2 g / mol. Calculate the mass of neon gas in SI units.

  What is the pressure drop associated with the airflow

What is the total rate of heat transfer to the air? What is the pressure drop associated with the airflow?

  Determine the force exerted by each cylinder

determine the force exerted by each cylinder in raising the crate for u = 60°, a 5 0.70 m, and L = 3.20 m. Show that the result obtained is independent of the distance d.

  Use steam tables to compute the total volume

Use steam tables to compute the total volume, total enthalpy, and total entropy of 1kg of water at 100o C, half by weight of which is steam and the remainder is liquid water.

  Determine the moments of inertia

two 20mm steel plates are welded to a rolled S section as shown. Determine the moments of inertia and the radii of gyration of the combined section with respect to the centroidal x and y axes.

  Determine the heat transfer coefficient for laminar flow

Determine the heat transfer coefficient for laminar flow over this cylinder. First, at your discretion, select an available set of experimentally obtained data from the literature. Then, this would provide you with a set of Reynolds numbers.

  Determine the air velocity

the air velocity in a duct is measured by a Pitot-static probe connected to a differential pressure gage. if the air is at 13.4 psia absolute and 70 degrees C and the reading of the differential pressure gage is 0.15 psi, determine the air velocit..

  Define geometric angle of attack

Geometric angle of attack, The Piper Cherokee has a wing area of 170 ft2 and a wing span of 32 ft. Its maximum gross weight is 2450 lbs. The wing uses a NACA 65-415 airfoil, which has a lift slope of 0.10331deg^-1 and alpha(L=0)= -3.0deg. Assume th..

  What is the allowable minimum length of the ramp

If the ramp height is 2ft. Using the ada code, what is the allowable minimum length of the ramp?

  Determine how much ice has melted to bring the temperature

(a) determine how much ice has melted to bring the temperature of the beverage to equilibrium with the ice/water. (b) Determine the final equilibrium temperature

  Determine the speed of collar after the applied force

the collar has a mass of 20kg and is supported on the smooth vertical rod. the attarched springsare undeformed when d=0.5m determine the speed of collar after the applied force F=100N causes it to be displaced so that d=0.3m when d=0.5m, the colla..

  What is the percent span for the old and new set points

In order to increase production rate a reactor set point was increased from 160 psig to190 psig. The reactor pressure transmitter was recalibrated from 0-200 psig to 0-300 psig.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd