Determine the potential at the vertex

Reference no: EM13291997

the right triangle with vertex P at the origin, base b, and altitude a has a uniform density of surface charge sigma. Determine the potential at the vertex P.

Reference no: EM13291997

Questions Cloud

Calculate the diode capacitances at a biases of 0v : A silicon diode with an area of 100mm´100mm is doped with ND=2e17cm-3 and NA=1e20cm-3. It has an IS=1fA, nonidealityfactor n=1 and tT=1ns. Consider room temperature of 300 Degree Kelvin.

Provide a brief statement on the issue : Should be succinct and to the point describing what the project is about. It is generally a one sentence statement and provide a brief statement on the issue and a concise outline of the paper content and structure.

Linear programming problem : Formulate the problem of finding the minimum cost way of sending flow through the network, from the source nodes to the sink nodes, subject to the node supplies/demands and the arc capacity restrictions, as a linear programming problem.

Design a circuit to multiply two 2-bit numbers : Design a circuit to multiply two 2-bit numbers -a,b and c,d and produce a 4-bit product -w,x,y,z. Show the truth table and the equations.

Determine the potential at the vertex : the right triangle with vertex P at the origin, base b, Determine the potential at the vertex P

What is the rms load current and determine the turns ratio : A step-down transformer has a 120V rms primary voltage applied and a 12V rms voltage is measured at thesecondary. Assuming the transformer can be considered ideal,determine the turns ratio, n.

What are some of the principal social institutions : What are some of the principal social institutions that are involved in music production and reception in your world? How do these various institutions contribute to the ways in which you experience, understand,and value the music that are a part of ..

Find to what voltage is the capacitor charged : The 95 mu F capacitor in a defibrillator unit supplies an average of 6500 W of power to the chest of the patient during a discharge lasting 5.0 ms

Determine what is the sensitivity in volts per degree : A potentiometer is used to measure the position of a shaft. theinput range of shaft position is from - 160o to +160o . the corresponding output range is from -20 to +20 v. what is the span of this position sensor

User Account

All Pages