Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
As part of a drainage improvement project, a drainage ditch will be straightened and cleaned. As a result, the lenght of the ditch will decrease from 1800 ft to 1400 ft and the mannings roughness factor will be reduced to 0.018 from 0.022. Determine the percentage increase in the discharge the ditch can accomodate at the same normal depth.
The undeformed length of the spring is l. Knowing that the collar is released from rest at x = and neglecting friction between the collar and the horizontal rod, determine the magnitude of the velocity of the collar as it passes through point C.
You are designing a highway to AASHTO guidelines on a rolling terrain where the design speed will be 60 mi/h. at one section, a +1.0% grade and a -3.0% grade must be connected with an equal-tangent vertical curve.
Average pore water pressure in fully saturated clay specimien, which was subjected to a pressure of 20N/cm^2 initially, was measured to be 7N/cm^2 after a period of time.
Demand for a particular product is normally distributed with a mean of 100 units and a standard deviation of 20 per period. if there are 120 units in inventory at the beginning of this period
Introduction to management science, The Dynaco Manufacturing Company produces a particular product in an assembly line operation. One of the machines on the line is a drill press that has a single assembly line feeding into it.
Assume that the sludge does not change density during filtration and that liquid removed from the sludge contains no sludge. Using mass-balance method. determine the volume of sludge after filtration.
You have determined that a 0.5 ppm concentration of copper sulfate should be applied to a lake to control the growth. The lake volume is 50 ac-ft. How many pounds of copper sulfate should be dissolved in the lake
Determine the force in each member of the truss and state if it is in tension or compression. Set P=400 lb and d=4 ft.
Calculate the average velocity (rnps), crosssectional area (rn"), and depth (m) for the stretch. To make these estimates, assume that the stretch can be idealized as a rectangular channel.
Discuss the different agencies, institutes, centers, different environmental companies that are active in UAE.
A 10-min experimental run shows that 75% of a reactant is converted to a product by a zero-order reaction rate. What would be the fraction converted in a half-hour run. Assume the reactor is a batch reactor.
The car's gear reduction ratio is 3.5 to 1, driveline efficiency is 90%, driveline slippage is 3.5%, and the road-wheel radius is 15 inches. What will the car's maximum acceleration be under these conditions on a level road
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd