Determine the number of gallons of paint needed to paint

Assignment Help Civil Engineering
Reference no: EM13318455

Determine the number of gallons of paint needed to paint the outside surface of the water-supply tank, which consists of a hemispherical bottom, cylindrical sides, and a conical top. Each gallon of paint can cover 250 ft^2

Reference no: EM13318455

Questions Cloud

Calculate critical depth and minimum specific energy : A rectangular channel of 20 f t width and having n = 0:017 carries flow of 800 f t^3/s. Calculate (a) critical depth (b) the minimum speci c energy (c) the speci c energy when depth of flow is 7 f t.
How many slices of pizza must you eat : Assuming a typical efficiency for energy use by the body, how many slices of pizza must you eat to walk for 1.5hr at a speed of 5.0 km/hr
The compound with a three-membered ring containing nitrogen : An epoxide is: Student Response Value Correct Answer Feedback A. any compound with a three-membered ring B. basically a cyclopropane C. any compound with a three-membered ring containing oxygen D. any compound with a three-membered ring containing..
What percent increase in shear force would be experience : What percent increase in shear force would be experience on the flat sides of a 40 ft long truck trailer as the truck speed increases from 65 mph to 75 mph. Kinematic viscosity of the air is 1.6x10^4 ft^2/s.
Determine the number of gallons of paint needed to paint : Determine the number of gallons of paint needed to paint the outside surface of the water-supply tank, which consists of a hemispherical bottom, cylindrical sides, and a conical top. Each gallon of paint can cover 250 ft^2
Find probability that in sample of bulbs will be defective : Find the probability that in a sample of 100 bulbs, (a) 0 bulbs will be defective (b) 1 bulbs will be defective (c) 2 bulbs will be defective (d) 3 bulbs will be defective (e) 4 bulbs will be defective (f) 5 bulbs will be defective
What is the minimum grade a student must get in order : The mean grade on a final examination was 72, and the standard deviation was 9. The top 10% of the students are to receive A's. What is the minimum grade a student must get in order to receive an A
Explain the total molar concentration of all the ions : What is the total molar concentration of all the ions in 0.020 M solutions of the following salts in water. 0.020 M KCl = ____ M ions 0.020 M CuSO4 = ____ M ions 0.020 M CaCl2 = ____ M ions
What is the amount of depreciation expense for 2014 : What is the amount of depreciation expense for 2014?

Reviews

Write a Review

Civil Engineering Questions & Answers

  Compute the new unit weight and moisture content of soil

A sample of soil was compacted into a 945 ml.laboratory mold. The mass of the compacted soil was 1850 grams and its moisture content was 13.1%. Specific gravity of solids is 2.70, Compute the moist unit weight, dry unit weight, and degree of satu..

  Determine is the flow rate typical for a bathroom faucet

Water in a household plumbing system originates at the neighborhood water main where the pressure is 480kPa, the velocity is 5m/s, and the elevation is 2.44 m. A 19 mm (3/4-in) copper service line supplies water to a two-story residence

  Determine the aeration period and f by m ratio

Two activated sludge aeration tanks in Podunk, MO are operated in series. Each tank has the follwing dimensions: 7.0 m wide x 28.0 m long x 3.5 m effective liquid depth.

  What is the minimum coefficient of road adhesion needed

The owners wish to achieve an initial acceleration from rest of 22 ft/(sec^2) on a level paved surface. What is the minimum coefficient of road adhesion needed to achieve this acceleration

  Sketch and label vi-vo and vn versus time

An inverting amplifier is implemented with a R1=10 kilo Ohms and R2= 100 Kilo Ohms, and an op amp with finite open-loop gain a=10^3 V/V. Sketch and Label Vi,Vo,and Vn versus time if Vi is a 1-kHz triangular wave

  Calculate the required diameter of steel tie rods

CALCULATE THE REQUIRED DIAMETER OF STEEL TIE RODS NECESSARY TO SUPPORT A BALCONY. EACH ROD, SUSPENDED FROM A ROOF TRUSS, SUPPORTS A FLOOR AREA OF 7.0m^2. THE COMBINED BALCONT FLOOR LOAD IS 10.5 kPa

  Determine the maximum axial compressive force to the bar

A short 60mm diameter circle bar is made of material for which the maximum safe compressive strees is 80 MPa and the maximum safe shearing strees is 30 MPa.

  Calculate the height of the capillary rise in the tube

A clean glass capillary tube having a diameter of .008 in. was inserted into water with a surface tension of 0.00504 lb/ft. Calculate the height of the capillary rise in the tube.

  Calculate the normal and shear stress on planes making angle

a tension member with cross-sectional area 3 in2 resists a load of 10 kips. How do you Calculate the normal and shear stress on planes making a 0, 20, 45, and 60 angle with the transverse section.

  Find the magnitude of the force on one side of plate

A rectangular plate 5ft by 4ft is at an angle of 30 degrees with the horizontal, and the 5-ft side is horizontal. Find the magnitude of the force on one side of the plate and the depth of its center of pressure when the top edge is (a) at the wate..

  What force is required to hold in equilibrium under mercury

A cube has side dimensions of 18.00 in. It is made of steel having a specific weight of 491 pcf. What force is required to hold it in equilibrium under mercury

  Determine diameter of second pipe is four times

water flows through a pipe of diameter 3 inches. If it is desired to use another pipe for the same flow rate such that the velocity head in the second pipe is four times the velocity of the first pipe.determine diameter of pipe

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd