Determine the normalized impedance from the load

Assignment Help Electrical Engineering
Reference no: EM13288459

Determine the normalized impedance at λ/8 from the load if (a) its normalized impedance is 2 +j, (b) its normalized admittance is 0.2 - j0.5, (c) the reflection coefficient at load is0.3 + j0.4.

Reference no: EM13288459

Questions Cloud

What clock code is required and what is first null bandwidth : A DS-SS system requires 40 db of CW rejection of an interfering signal. it uses an 8-stage shift register m-sequence generator and transmits 1.5 kbps binary message data an a 2 GHz carrier. What clock code is required and what is the first null ba..
Determine what step should the code be set to : A spread spectrum system has a code rate that can be switched from 500 kbps to 1.5 Mbps in 100 k steps. If the message rate is 1.3 kbps and the processing gain is 1050. What step should the code be set to
Design logic circuit to control electrical power to engine : Design a logic circuit to control electrical power to the engine ignition of a speed boat. Logic output I is to becomehigh if ignition power is to be applied and is to remain lowotherwise. Gasoline fumes in the engine compartment present aserious ..
Explain wedge-and-dash bonds for the substituent groups : Use wedge-and-dash bonds for the substituent groups, and be sure that they are drawn on the outside of the ring, adjacent to each other
Determine the normalized impedance from the load : Determine the normalized impedance at λ/8 from the load if (a) its normalized impedance is 2 +j, (b) its normalized admittance is 0.2 - j0.5, (c) the reflection coefficient at load is0.3 + j0.4.
What will one share of b&k common stock be worth : The company adheres to a constant rate of growth dividend policy. What will one share of B&K common stock be worth 10 years from now if the applicable discount rate is 9 percent?
Find current i flowing in bar and resistance of the wire : A cylindrical wire of silicon has a radius of 1 mm and a length of8 cm. If a voltage of 5V is applied between the ends of the bar andμe = .11 m2/Vs, μh = .04m2/Vs, Ne = 1020electrons/m3 and Nh=Ne find the following
What is the amount of the next annual dividend : The Printing Company stock is selling for $32.60 a share based on a 14 percent rate of return. What is the amount of the next annual dividend if the dividends are increasing by 2.5 percent annually?
Determine the maximum charge the cloud can hold : Regarding the Earth and a cloud layer 700 m above the Earth as the "plates" of a capacitor, What is the maximum charge the cloud can hold

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the voltage van at the low-voltage bus

3-singlephase 2 winding transformers, each rated 500 MVA, 13.8/199.2 kV, with leakage reactance Xeq = 0.10 per unit, are connected to form a three-phase bank. Winding resistances and exciting current are neglected.

  Find the magnitude and phase as function of f

A military satellite uses 10 GHz for the downlink frequency. The distance to the satellite is approximately 36000 km. if the satellite transmitter produces a power of 50 dBm with a transmit antenna gain of 20 dB and on the ground

  Calculate the instantaneous power absorbed by the resistor

A voltage v(t) = 359.3 cos(wt) is applied to a load consisting of a 10 resistor in parallel with a capacitive reactance XC = 25. Calculate The instantaneous power absorbed by the resistor The instantaneous power absorbed by the capacitor

  Calculate the cost of generated electricity in second case

n other case Trackers have the ability to increase power generated by direct radiation by 40 %. However, the cost of installed system (including trackers) will be $2.60 million. Calculate the cost of generated electricity in the second case.

  What will be the output of the adc in binary form

An embedded system with a 8 bit analog to digital converter is connected to a transducer with an output voltage of 20 millivolts. This signal is then amplified by an amplifier with a gain of 50. Assume that this signal level is appropriate for the..

  Give a gate level schematic diagram for the circuit

design an arithmetic incrementer/decrementer circuit. Your circuit will recieve a 3-bit binary number (A) as input to produce an output which is either A+1 or A-1 depending upon the command input (ID).

  Calculate the magnetic flux per winding through the coil

The inductance of a closely packed coil of 400 turns is 9.5 mH. Calculate the magnetic flux (per winding) through the coil when the current is 5.0 mA.

  Design a digital circuit that can be attached to school bill

Design a digital circuit that can be attached to a school bill which can work automatically from 7:00 AM to 12:45 PM, and it has the following features: 1- Rings for 5 seconds. 2- Start ringing 7:00 AM to announce for the field gathering. 3- Rings 7:..

  Calculate the resistance of the coil of copper wire

A coil made of 150 turns of copper wire wounded ona cylindrical coil . If that means radius of the turns in 6.5mm and the diameter of the wire is 0.4mm, calculate the resistance of the coil.

  Calculate the steady-state excess electron concentration

There are contacts at the two ends, x=0,W. The contact at x=0 is transparent. Light falls on the contact at x=0 creating electron-hole pairs at a rate GL(x)=GL,0 exp(-x/λ), λ =/= L0. Calculate the steady-state excess electron concentration.

  Find loading error when the pot is in middle of its range

A 10 K-ohm pot is used as a position sensor with a 10 -V supply. The input resistance to the interface circuit is 50 K-ohm. Find the loading error when the pot is in the middle of its range.

  Find the self inductances l1 and l2 and mutual inductance

2 coils are 80% magnetically coupled for a magnetic system. Suppose that coil 1 is excited by AC voltage V1=200 v with current I1=1 A, all in rms values at 60Hz, while coil 2 is open and receives an induced voltage V2 = 50 v in rms.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd