Determine the no-load voltage and the full-load voltage

Assignment Help Electrical Engineering
Reference no: EM13254508

A permanent magnet DC generator has a
\(k\phi\)
value of 8 Wb and RA of 13 ohms. The prime mover rotates the armature at a speed of 1000 rpm. Determine the no-load voltage, the full-load voltage, and the torque required by the prime mover at full load if the full-load power required by the load is 3 kW (assuming most of the power is delivered to the load) neglecting rotational losses.

Reference no: EM13254508

Questions Cloud

What is the equilibrium constant at the temperature : The splitting of ATP can be schematically given as ATP H2O ?ADP P. what is the equilibrium constant at the temperature
What fraction of the input power makes it to the output : Find the maximum allowed developed torque and corresponding motor speed that will ensure that no more than 25% of the power is lost in conductive losses in the armature and field windings.
Explain what is the activation energy of the reaction : If a 20.0 °C drop in temperature causes a fortyfold decrease in reaction rate for a certain reaction, what is the activation energy of the reaction
What is the change in the trucks kinetic energ : A 2700 kg truck traveling north at 42 km/h turns east and accelerates to 53 km/h. What is the change in the truck's kinetic energy
Determine the no-load voltage and the full-load voltage : The prime mover rotates the armature at a speed of 1000 rpm. Determine the no-load voltage, the full-load voltage, and the torque required by the prime mover at full load if the full-load power required by the load is 3 kW
At what point does break-even occur : Also calculate the overall return on investment of the project and then present a break-even analysis. At what point does break-even occur?
Determine the final temperature of the coffee : A thermos contains 170 cm3 of coffee at 85° C. To cool the coffee, you drop two 14-g ice cubes into the thermos. What is the final temperature of the coffee
Describe what will the temperature be when the ice cube : An ice cube that is 25.00 g (temp -20 C) is placed into 225.00 g of H2O that is 22 degrees C. What will the temperature be when the ice cube has just melted. Use 4.184 J/K*g for the specific heat capacity of ice and water.
Explain how irq interrupt works when it is activated : Assume that the I bit for external hardware interrupt IRQ is enabled and is low-level triggered. Explain how this interrupt works when it is activated. How can we make sure that a single interrupt is not interpreted as multiple interrupts

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the probability that a tick carries both l and h

Deer ticks can carry both Lyme disease (L) and human granulocytic ehrlichiosis (H). In a study of ticks in the Midwest, it was found that 16% carried L, 10% carried H and 25% that had either L or H carried both.

  At what frequency is impedance a minimum

A series-resonant RLC circuit has R = 80 (ohms), L=25mh, and C=10pF. A) Sketch and label the circuit. B) Find fo, the resonant frequency. C) At what frequency is impedance a minimum D) What is the magnitude of the impedance at this frequency

  Find line current-power factor and complex power

Three loads 3+4j are connected in delta to a 208-V, three phase line find line current, power factor, real power, reactive power and complex power

  Find the net heat transfer for the process in kj

50 kg of a certain gas is contained within a piston-cylinder assembly. the gas undergoes a processwhich the pressure volume relationship is PV = constant. (n=1.5) the given conditions as follows : p1= 6 bars, v1=0.2 cubic meters ,and v2= 0.4 cubic..

  Estimate the propagation delays of implementations

Estimate the propagation delays of implementations (1), (2) and (3) using typical propagation delay data in the timing specifications of the logical gates of CD4000 family. Take the average propagation delay for 1-0 and 0-1 output transitions.

  What is probability that customer will only be able internet

An internet access provider (IAP) owns two servers. Each server has a 50% chance of being "down" independently of the other. Fortunately, only one server is necessary to allow the IAP to provide service to its customers

  Design interface between a computer output port and em relay

An alarm is powered by 120 VAC, and the on/off state of the alarm is controlled by an EM relay. Design the interface between a computer output port and the EM relay. The dropout voltage is 3.5 V, and the coil current needs at least 100 mA.

  Evaluate cross or auto correlation

You have to figure out which one using cross or auto correlation.

  Calculate the maximum power

Calculate the maximum power that can be sent through an a=2cm , b=1cm air-filled waveguide at 12 GHz such that dielectric breakdown does not occur. Assume that the dielectric strength of air at atmospheric pressure is 3x10^6 [V/m]

  Find the min permissible sag for a span of 225 m

find the MIN permissible SAG for a span of 225 m using a copper conductor with 1.2 cm diameter and allowing a MAX conductor tension of 2200 kg/cm^2 . The horizontal wind pressure is 6 g/cm^2 and specific gravity of copper is 8.9

  What is the power in watts supplied to the circuit

he peak voltage supplied to an AC circuit is 20 V. The peak current is 2.5 A. The angle between the voltage and current is 30 degrees. What is the power in Watts supplied to the circuit 4. The rms voltage supplied to an AC circuit is 24 V.

  What is the resulting maximum information transfer rate

The serial ports on two computers which use binary signaling are connected by a twisted pair cable. The cable has a flat frequency response up to 120KHz, with negligible group delay distortion. That is, the bandwidth of the cable is 120KHz.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd