Determine the net power delivered to the generator

Assignment Help Civil Engineering
Reference no: EM13326439

An adiabatic air compressor is to be powered by a direct coupled adiabatic steam turbine that is also driving a generator. Steam enters the turbine at 12.5 MPa and 500oC at a rate of 25 kg/s and exits at 10 kPa and a quality of 0.92. Air enters the compressor at 98 kPa and 295 K at a rate of 10 kg/s and exits at 1 MPa and 620 K. Determine the net power delivered to the generator by the turbine.

For air, take the specific heat at constant pressure as 1.005 kJ/kg.K

Reference no: EM13326439

Questions Cloud

What are some of the parameters that would be taken : A jet on an aircraft carrier is launched by a catapult. What are some of the parameters that would be taken into account to make sure the aircraft achives a specified speed at the end of the ship
Discuss how relative motion is critical issue in the midair : Discuss how relative motion is a critical issue in the midair refueling of aircraft. Would control of this process be with the pilot of the tanker or the aircraft being refueled
How many hosts can there be in each subnet : Choose all the necessary and suitable MAC address, IP address for interfaces and port addresses implied by the above description.
Does stitching on ball have any influence on the trajectory : A baseball is hit from home plate and travels over the center field fence. What would the trajectory of the baseball look like if air-resistance was not factored in
Determine the net power delivered to the generator : Air enters the compressor at 98 kPa and 295 K at a rate of 10 kg/s and exits at 1 MPa and 620 K. Determine the net power delivered to the generator by the turbine.
Determine the velocity and the volume flow rate of the steam : Steam enters a nozzle at 400oC and 800 kPa with a velocity of 10 m/s, and leaves at 300oC and 200 kPa while losing heat at a rate of 25 kW. For an inlet area 0f 800 cm2, determine the velocity and the volume flow rate of the steam at the nozzle ex..
Calculate the rate enhancement caused by the enzyme : An uncatalyzed reaction has a rate of 4.2 x 10-7 sec-1. When an enzyme is added the rate is 3.2 x 104 sec-1. Calculate the rate enhancement caused by the enzyme.
What are biosynthetic pathways in cells anabolic produce atp : what are biosynthetic pathways in cells A) anabolic B) catabolic C) usually produce more atp than they consume D) release monmorsinto the cytoplasm
Find what are the probable genotype of the parent plants : Color in a type of squash is controlled by a single gene. The squash can be either white or yellow, with white squash (W) dominant to yellow (w). if 1/2 of the offspring are white, what are the probable genotype(s) of the parent plants

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the rate at which heat must be transferred

A 50-ohm electrical resistor carries a current of 5 amperes. The resistor is maintained at a temperature of 30o C. Determine the rate at which heat must be transferred to the surroundings

  Horizontal axle passing through center

A 75g , 30cm--long rod hangs vertically on a frictionless, horizontal axle passing through its center. A 12g ball of clay traveling horizontally at 2.5m/s hits and sticks to the very bottom tip of the rod.

  What is the diameter d of the smallest -size particles

in a hydrometer test , the results are as follows:Gs =2.60 , temperature of water=24c ,and R=43at 60 min after the start of sedimentation . what is the diameter , D, of the smallest -size particles

  Find the flow rate in m3 per s when water flows uniformly

Water flows uniformly in a 6 m wide rectangular channel at a depth of 0.8m. The channel slope is 0.0015 and n=0.014. Find the flow rate in m3/s

  Falling-head permeability test

A falling-head permeability test was carried out on a clay soil of diameter 100 mm and length 150 mm. In 4 minutes the head in the standpipe of diameter 5mm dropped from 680 to 350 mm.

  Find the length of the studs in a rake wall with base height

Find the length of the studs in a rake wall with a 5:12 pitch, a half span of 9'4", 16" OC and a base height of 7'3".

  Plot transition from tangent to full superelevated section

The superelevation rate is 0.084. Prepare a plot showing the ordinates required for the transition from the tangent section to the full superelevated section, assuming that the pavement width is 7.3 m wide. Make any necessary assumptions.

  What are the reasons for organisms that have mercury

What is (are) the reason(s) for organisms that have mercury concentrations different than what is predicted to occur just by bioconcentration

  Explain how to estimate the et losses for the area in 1 year

It the mean annual runoff of a drainage basin of 10000 km^2 is 140 m^3/s, and the average annual precipitation is 105 cm, estimate the ET losses for the area in 1 year. What are your assumptions

  How many short tons of coal are required

How many short tons of coal are required by this plant per year, assuming it operates continuously? If 10% of the coal mass remains as residual ash, how many tons will develop in the ash pile over 25 years?

  What is the departure rate when the queue reaches vehicles

The arrival rate at a parking lot is 6 veh/ min. Vehicles start arriving at 6: 00 P. M., and when the queue reaches 36 vehicles, service begins. If company policy is that total vehicle delay should be equal to 500 veh-min, what is the departure ra..

  Determine the settlements

Determine the settlements when a stress of 100 kPa is applied by the building over an area of 10m × 5 m on the soil surface.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd