Determine the minimum required wire diameter assuming

Assignment Help Civil Engineering

Reference no: EM13536840

1.Calculate the required area of an air to air heat exchange to cool 20,000 cfm from 1200 F to 400 F. Assume ambient air at 80 F will be heated to 800 F by the exchange. Assume heat losses are 10 % and that the overall heat transfer coefficient is 1.0 Btu/hr-ft^2- °F

2.Argon is expanded in an isentropic turbine from 2 MPa and 500oC to 200 kPa. Determine the outlet temperature and the work produced by this turbine per unit mass of argon.

3.Saturated R-134a vapor enters a compressor at 0 degrees F. At compressor exit, the specific entropy is the same as that at the inlet, and the pressure is 60 psia. Determine the R-134a exit temperature and the change in the enthalpy of R134a.

4.A large steel tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 19,000N. Determine the minimum required wire diameter assuming a factor of safety 5 and that the yield strength of the steel is 900MPa.

Reference no: EM13536840

Questions Cloud

Complete one revolution and is driven by three rollers : A microwave oven has a rotating plate for uniform cooking. The plate takes 8 seconds to complete one revolution and is driven by three rollers.

Calculate the required area of an air to air heat exchange : Calculate the required area of an air to air heat exchange to cool 20,000 cfm from 1200 F to 400 F. Assume ambient air at 80 F will be heated to 800 F by the exchange. Assume heat losses are 10 % and that the overall heat transfer coefficient is 1.0 ..

The shear enters through the center at the top of the cross : In part (a) of this question we are asked to calculate τmax. In order to do this we separate the cross section at the neutral axis and take the entire upper half (as shown in the cramster solution).

What is fc and d : 5 1/8 in thick laminated timber 24ft long column to support a roof 16 kips and floor load 38kips will be applied at 13' 4" from base.

Determine the minimum required wire diameter assuming : A large steel tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 19,000N. Determine the minimum required wire diameter assuming a factor of safety 5 and that the yield strength of the steel is 900M..

Determine the entrance losses : A 40 cm diameter well has been constructed in a water-table aquifer. A pump capable of continuous discharge at 600 m3/day has been installed to test the well. Observation wells are located 10 meter and 50 meters from the pumped well. After pumping co..

What is the coefficient of static friction : A chair weighing 150 rests on a level floor that is not frictionless. A man pushes on the chair with a force = 43.0 that is directed at an angle of 34.0 with the horizontal. Assume that the chair is stationary but is on the verge of sliding.

When a net amount of work is done on a closed : When a net amount of work is done on a closed system undergoing an INTERNALLY REVERSIBLE process, a net heat transfer of energy from the system also occurs.

What length of time in the model corresponds to one day : A 1:2000 scale tidal model is operated to satisfy Froude’s law. A velocity of 0.02 ft/s is observed in the model. What is the velocity at the corresponding point in the prototype? What length of time in the model corresponds to one day in the prototy..

User Account

All Pages