Determine the minimum and the maximum values

Assignment Help Electrical Engineering
Reference no: EM13282333

An op-amp based amplifier has +/- 51 V supplies and a gain of -80.Over what input range is the amplifier linear. Find (a) the minimum and (b) the maximum values.

Reference no: EM13282333

Questions Cloud

Find what would to have in the hdl description : FPGAs are programmed from acompiled HDL description (i.e., a Verilog or VHDL program). What would you have to have in the HDL description to use the globalset/reset function in the Spartan FPGA
State the molar enthalpy of combustion for the compound : A 0.2254g sample of naphthalene (C8H10, 128.16g/mol) was burned in a bomb calorimeter with a heat capacity of 2.18kJ/K and temperature increased by 4.16 Celcius, what is the molar enthalpy of combustion for this compound
Devise a way to address words of memory using fewer n pins : As more and more memory is squeezed onto a single chip, the numberof pins needed to address it also increases. It is often inconvenient to have large numbers of address pins on a chip. Devise a way to address 2^n words of memory using fewer than n..
Define the ionic and net ionic equations : Write and balance the molecular equation and then give the ionic and net ionic equations for the neutralization reaction between NH3(aq) and H2SO4(aq).
Determine the minimum and the maximum values : An op-amp based amplifier has +/- 51 V supplies and a gain of -80.Over what input range is the amplifier linear. Find (a) the minimum and (b) the maximum values.
Explain carbon tetrachloride may react with oxygen : Carbon tetrachloride may react with oxygen to produce chlorine and carbonyl chloride.2CCl4(g) + O2(g) 2COCl2(g) + 2Cl2(g); Kc = 9.9 × 10^51. What is Kc for the following equilibrium?COCl2(g) + Cl2(g) CCl4(g) + ½O2(g)
Explain what is the equilibrium concentration of hii2(g) : In an experiment, 0.32 mol H2 and 0.32 mol I2 are mixed in a 1.00-L container, and the reaction forms HI. If Kc = 49. for this reaction, what is the equilibrium concentration of HI?I2(g) + H2(g) 2HI(g)
Derive the circuits for a three bit parity generator : derive the circuits for a three bit parity generator and four bit parity checker using an odd parity bit.
Describe the kirchoffs rule : In the figure, two ideal solenoids link the circuit, with the solenoids' magnetic fields directed as shown. Use Kirchoff's rules to find the current in each resistor

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the emission coefficient n

Power Electronics - Diode, [Power electronics] The measured values of a diode at a temperature of 25 Degrees Celsius are: Vd=1V at Id=50A, Vd=1.5V at Id=600A. Determine (i) the emission coefficient n, and (ii) the leakage current.

  Find the electric field produced by the two rods

Two thin rods of length L lie on the x axis. One of them has a charge of -Q uniformly distributed along its length and is positioned between x = -L and x = 0. The other one has a charge of +Q uniformly distributed along its length.

  Find maximum reverse voltage that will appear across diode

It is required to use a peak rectifier to design a dc power supply that provides an average dc output voltage of 15 V on which a maximum of 1-V ripple is allowed. The rectifier feeds a load of 150 ohm.

  What value of field current will result in a unity pf

A synchronous motor is drawing 90 amps from 240V, 3 phase line at 0.8 pf leading with field current adjusted to 1.2 amps. The synchronous machine Xd is 1.3 ohms. Find a). The power angle delta

  Determine what is the equivalent resitance of the bulb

3W light connected to ideal 9V battery with ideal wires a) Draw diagram using circuit symbol for a resistor in place of bulb b) What would current draw from bulb be. I= c)What is if the equivalent resitance of the bulb

  Estimate the rate of heat transfer from the compressor

50 kmol per hour of air is compressed from p1 = 1.2 bar to P2 = 6.0 bar in a steady-flow compressor. Delivered mechanical power is 98.8KW. Temperature and velocities are: T1= 300K T2= 520K u1= 10m s^-1 u2= 3.5m s^-1

  What is the maximum data rate that can be transmitted

A radio channel has a bandwidth of 10 KHz and a SNR of 15 dB. What is the maximum data rate that can be transmitted: (a) Using any system (b) Using a code with 64 possible states

  Determine the output y if the input to the system is given

Determine the output y(t) if the input to the system is given by x(t) = u(t) - u(t-2) using complex-domain (not time-domain) analysis techniques.

  Find internal power developed by motor when it is operating

A star connected synchronous motor at 187 kVA, 3-V, 2300V, 47A, 50Hz, 187.5 rpm has an effective resistance of 1.5 ohm and a synchronous reactance of 20 ohm per phase. Determine internal power developed by the motor when it is operating at rated c..

  How many transistors would the design require

Design a 16 bit x 16 bit combinatorial multiplier. Use a topology similar to the 4x4 multiplier.

  Why the fermi energy level will not contain an electron

Assume that the Fermi energy level for a particular material is 6.25eV and that the electrons in this material follow the Fermi-Dirac distribution function. Calculate the temperature at which there is a 1% probability that a state 0.30eV

  What is the mod number required for a counter

The common crystal used in older color teleisions outputs a 3.58002 MHz signal. What is the MOD number required for a counter to reduce this to a 60Hz output

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd