Determine the maximum water hammer pressure if the initial

Assignment Help Civil Engineering

Reference no: EM13545621

A 1000 ft long steel pipe carries water from a reservoir with a water elevation at 826 ft. The pipe has a diameter of 12 in. with a wall thickness of .5 in. A gate valve at the downstream end is slowly closed during a half-mintue period. Determine the maximum water hammer pressure if the initial pressure at the valve was measured to be 742 ft above the datum. The elevation of the valve is 545 ft.

Reference no: EM13545621

Questions Cloud

What is the estimated collection efficiency to improve its : Our ESP is collecting 95% of the particles in our exhaust stream. We are under pressure to improve its performance. It has been suggested that if we were to cool the inlet gas from the present 600°F to 250°F, the performance would improve

Calculate head supplied by the pump draw hgl and egl for : Water from a lower reservoir (water surface elevation) 500 m is pumping to the upper reservoir (water surface elevation 600 m) through a 5000 m long straight pipe with 0.5 m diameter.

Determine the rate at which heat must be transferred to the : Saturated liquid water at 1.0 MPa is throttled adiabatically to a pressure of 0.4 MPa. If the change is kinetic energy is negligible, what percentage of the water evaporates during this throttling process?

What is the local loss coefficient of the basket strainer : A basket strainer is installed in a 15-cm diameter pipe. Pressure gauges are installed immediately upstream and downstream of the basket strainer. When water flows at 100 m3/hr, the pressure gauge immediately upstream of the basket strainer measures ..

Determine the maximum water hammer pressure if the initial : A 1000 ft long steel pipe carries water from a reservoir with a water elevation at 826 ft. The pipe has a diameter of 12 in. with a wall thickness of .5 in. A gate valve at the downstream end is slowly closed during a half-mintue period

Calculate the total head loss for water flowing at 10 : Calculate the total head loss for water (25°C) flowing at 100 m3/hr as shown in the following figure. The total flow length is 250 meters and the pipe is 15-cm diameter cast iron pipe

What is the estimated collection efficiency at 250f : Our ESP is collecting 95% of the particles in our exhaust stream. We are under pressure to improve its performance. It has been suggested that if we were to cool the inlet gas fron the present 600F to 250F, the performance would improve.

Determine the design load for strength and service ability : Determine the design load for strength and serviceability limit states (short-term and long term), for a steel beam in a residential building with the following data;

What pipe diameter is needed to discharge gasoline : Gasoline is being discharged from a pipe at point 2 at elevation 66.66 m. Pint 1, located 965.5 m along the pipe from point 2, is at elevation 82.65 m

User Account

All Pages