Determine the maximum torsional stress in the shaft and its

Reference no: EM13536728

The propellers of a ship are connected to an A-36 steel shaft that is 60m long and has an outer diameter of 340mm and inner diameter of 260mm. If the power output is 4.5MW when the shaft rotates at 20rad/s, determine the maximum torsional stress in the shaft and its angle of twist.

Mechanical properties of A-36 steel can be found in Appendix B

Reference no: EM13536728

Questions Cloud

What percent of the produced water do they waste : A municipal water plant has four filters that are each 20 ft long by 15 ft wide by 5 ft deep. The demand for water requires that they only operate, on average, three filters per day at a loading of 3 gallons per min / ft^2.

Estimate the velocity with which you would contact : Estimate the velocity with which you would contact the ground if you jumped from an airplane at an altitude of 500ft and a) air resistance is negligible, b) air resistance is important, but you forgot your parachute, and c) you use a 25-ft-diameter p..

Estimate the flow rate when draw down : A fully penetrating well of 30 cm diameter in an unconfined aquifer of saturated thickness 50 m was found to give the following draw down - discharge relationship under equillibium condition.

Where the function changes a lot or where the function : As a further exercise, try to find values of t for your approximation that keeps the error (i.e., the difference between the approximation and the real function v(t) ) less than 0.1.Hint: to help with this, ask yourself this question: where would mor..

Determine the maximum torsional stress in the shaft and its : The propellers of a ship are connected to an A-36 steel shaft that is 60m long and has an outer diameter of 340mm and inner diameter of 260mm

What is the latitude of your location : Draw an inverted bowl – i.e., a horizontal line (exactly 10 inches long), with a big semi-circular upside-down “U” connecting the ends of that horizontal line. This is a picture of the ground and sky. Draw a little tiny person (you) at the mid-point ..

What possible corrective actions could have been implemented : For Hartford civic center roof collapse disaster. What possible corrective actions could have been implemented to prevent this failure? explain in your own words.

What is the minimum l/g that you would approve : A company has submitted plans for a hydrogen sulfide (H2S) scrubber.H2S is to be removed from the waste air discharge by scrubbing with a dilute

Calculate the settling velocity of a spherical particle : Use Stoke’s Law to calculate the settling velocity (m/s) of a spherical particle with a diameter of 1.0 mm and a density of 3 g/mL in water at a temperature of 30?C. The dynamic viscosity of water at 30?C is 0.798 x 10-3 N s/m2. The density of water ..

User Account

All Pages