Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A vehicle of mass 1500kg and track 1.8m has a centre of mass located centrally at 1,1m above the ground. It has to travel around a bend of 56m radius to the centre of mass.
a) Assuming that the vehicle does not slide, determine the maximum speed if the vehicle is not to fall over.
b) If μs=0.25 on the bend in the wet, find the maximum speed if the vehicle is not to slide.
Use steam tables to compute the total volume, total enthalpy, and total entropy of 1kg of water at 100o C, half by weight of which is steam and the remainder is liquid water.
Air enters a 0.6 m diameter fan at 16 deg C, 101 kPa, and is discharged at 18 deg C, 105 kPa, with a volumetric flow rate of 0.35 m^3/s.
Determining the largest couple that can be applied to a beam in pure bending. A beam of cross section shown is extruded from an aluminum alloy for which σy = 310 MPa and σu = 480 MPa.
Assuming the plant operates on the ideal vapor-compression cycle using refrigerant 134-a between the pressure limits of 120 and 700 kPa, determine
Apparent Density, Theoretical Density and Void Volume, A compacted body of iron powder is sintered into a 20mm-diameter, 45-mm-tall cylinder which, upon weighing
A steady flow air compressor compresses 50 lb/min from 14 psia and 80 degrees F to a discharge state at 45 psia and 300 degrees F. Heat departs from the air only via circulating water that enters the jacket at 75 degrees F and leaves at 95 degrees..
Find the safe applied torque that can be transmitted by the shaft ABCD, if the maximum shear stress in the hollow section is 47 MPa and G = 82.5 GPa.
Use the bisection method to determine the drag coefficient (cd) needed so that a 80 kg bunjee jumper has a velocity of 36 m/s after 4 s of free fall.
How many kilograms each of pearlite and the proeutectoid phase form? Schematically sketch and label the resulting microstructure.
What happens to the cutting and thrust force as tool rake angle and cutting speed are increased and what is the relation between the cutting and thrust forces to the depth of cut?
A circular shaft is subjected to a torque Ta and a bending moment Ma. Assuming that the diameter of the shaft is d, determine the expressions for the principal stresses and maximum shear stress in terms of Ma, Ta and d.
What is the couple moment of the two couples that act on the pipe assembly. The distance from A to B is d = 400 mm.express the result as a cartesian vector.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd