Determine the maximum power supplied by the engine

Assignment Help Mechanical Engineering
Reference no: EM13701071

A sports car has a mass of 2000 kg and an engine running at an efficiency of 0.63, as it moves forward with a constant velocity of v=50 m/s,the wind creates a drag resistance on the car of FD=1.2v^ newtons. Determine the maximum power supplied by the engine.

Reference no: EM13701071

Questions Cloud

Fluid is ethylene glycol under the same flow conditions : For a laminar boundary layer flow over a flat plate with air at 20°C and 1atm, the thermal boundary layer thickness Dt is approximately 13% larger than the velocity boundary layer thickness D. Determine the ratio D/Dt if the fluid is ethylene glycol ..
Piston cylinder device contains : A piston cylinder device contains .733 kg of refrigerant-134a at -10 degrees C. The piston that is free to move has a mass of 8.63 kg and a diameter of 21.2 cm. The local atmospheric pessure is 88 kPa. Now, heat is transferred to the refridgerant-134..
How many times can he jump on his bed before beam breaks : After one particularly wild night at the bars, Jon decides to come home and jump on his bed .Assume that he's jumping directly in between one steel support beam that's 10 foot long, 2 inches wide and 1 inch thick. Further assume that Jon weighs aroun..
What is tension in swing cable developed during the motion : A gentry structure, similar to a tire swing, is used to test the response of an airplane is hoisted back until the 20m swing cable is at theta=60. Determine the speed of the plane just before crashing into the ground at theta=15, when released from r..
Determine the maximum power supplied by the engine : A sports car has a mass of 2000 kg and an engine running at an efficiency of 0.63, as it moves forward with a constant velocity of v=50 m/s,the wind creates a drag resistance on the car of FD=1.2v^ newtons. Determine the maximum power supplied by the..
Coefficient of kinetic friction between the wheels and road : A 3500 Ib. automobile is traveling down a 10 incline a 20 ft/./s. if the driver slams the break, causing the wheels to lock , determine how far the tires slide. the coefficient of kinetic friction between the wheels and the road is uk=0.5
Calculate adiabatic flame temperature butane burning : Calculate adiabatic flame temperature butane (C4H10) burning in air at 298 k and 1 atm, assuming complete combustion and constant specific heats.
An ideal refrigeration cycle : An ideal Refrigeration cycle with R134a as the working fluid consists of isentropic compression from saturated vapor at -10 C, constant-pressure heat rejection in the condenser5 at 39 C, constant- enthalpy pressure loss across a throttle valve, and c..
Compute the complex dynamic shear modulus : Binder Classification (Grading) What is the best possible PG grade of the asphalt whose results are shown in Table 4 below? Use Table 9.3 from M&Z at end of assignment to help.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Advanced design methodologies

Focus mainly of consumer items such as iPods, coke bottles, running shoes

  The thermal conductivity of the solid is 190 wm-k and its

a solid cylinder 100 mm in diameter generates heat at a uniform rate of 7 x 106 wm3. the thermal conductivity of the

  Calculate the adiabatic flame temperature

Calculate the adiabatic flame temperature (at constant pressure) for ethane C2H6 in air

  Ten kilograms of ice at 260 k is duped into 20 kg of

ten kilograms of ice at 260 k is duped into 20 kg of liquid water initially at 300 k in an insulated container. the

  A nylon thread is subjected to a 10-n tension knowing that

a nylon thread is subjected to a 10-n tension. knowing that e 3.2 gpa that the maximum allowable normal stress is 40

  A four foot diameter reel of wire pays out 250 feet of

a four foot diameter reel of wire pays out 250 feet of conductor wire in two minutes. what is the average angular

  What fractional change in absolute temperature from 20c

underwater submersibles must match the local density in order to remain neutrally buoyant. maximum dive depths for

  During a gust of wind the blades of the windmill are given

during a gust of wind the blades of the windmill are given an angular acceleration of 0.2 rads2 where is measured in

  Describe how the permittivity might change with time for a

many important engineering structures are often coated in a protective paint layer of some kind. this is not simply to

  Sample b is dry but the density is the same as that of

two samples of air at 1 bar pressure are considered. sample a is at 27 degrees c with 80 per cent relative humidity.

  What is the effect of the propane addition on the mole

a system of propane and n-butane exists in two phase vapor liquid equilibrium at 10 bar and 323 k. the mole fraction

  A motorist enters a freeway at 36 kph and accelerates

a motorist enters a freeway at 36 kph and accelerates uniformly to 90 kph. from the odometer in the car the motorist

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd