Determine the maximum permissible torque tmax

Reference no: EM13552826

The composite shaft is made of a steel sleeve, which is bonded to a brass core. The outer diameters of the two parts are d1 = 40 mm for the brass core and d2 = 50 mm for the steel sleeve. The shear moduli of elasticity are Gb = 36 GPa for the brass and Gs = 80 GPa for the steel. Assuming that the allowable shear stresses in the brass and steel are ?b = 48 MPa and ?s = 80 MPa, respectively, determine the maximum permissible torque Tmax that may be applied to the shaft without any material failure. The torques are applied each at the end of the shaft opposite directions.

Reference no: EM13552826

Questions Cloud

What is the overall product water recovery and salt : A city is considering a 3 stage membrane system to treat brackish groundwater at its water treatment plant, WTP (Qf=1000m^3/d, Cf=2000mg/L TDS). Each stage can perform 60 % water recovery (Qp/Cf) and 90% salt rejection (1-Cp/Cf)

How long after the rope becomes taut until car b collides : The cars have equal mass. Car A is suddenly given velocity 4 m/s and the rope becomes taut. We know that 40 percent of the system’s kinetic energy is lost during the rope tensioning.

Whistleblower was justified in reporting the company : Decide whether or not the whistleblower was justified in reporting the company's actions. Provide a rationale for your response. I choose Ranbaxy Laboratories

What will be the manometer deflection : The pressure inside a 4 cm hose is 700 kPa. If the water exits through a 2 cm diameter nozzle, what velocity in m/s, can be expected inside the hose ?

Determine the maximum permissible torque tmax : The composite shaft is made of a steel sleeve, which is bonded to a brass core. The outer diameters of the two parts are d1 = 40 mm for the brass core and d2 = 50 mm for the steel sleeve.

The treaty and accompanying implementing legislation : The treaty and accompanying implementing legislation were approved

Determine the isentropic compressor efficiency : Refrigerant 134a enters the compressor of a vapor compression heat pump at 15 psi and 0 °F and is compressed to 160 psi and 160 °F. Liquid enters the expansion valve at 160 psi and 95 °F. At the valve exit the pressure is 15 psi.

Determine the vertical stress increment due to the strip : Determine the vertical stress increment due to the strip load and the total pressure both at point 3 m below the center of the strip load.

Increase the level of economic and social integration : Increase the level of economic and social integration

User Account

All Pages